Question:
For purchasing a batch reactor, three alternatives P, Q and R have emerged, as summarized in the table. For a compound interest rate of 10% per annum, choose the correct option that arranges the alternatives, in order, from the least expensive to the most expensive
For purchasing a batch reactor, three alternatives P, Q and R have emerged, as summarized in the table. For a compound interest rate of 10% per annum, choose the correct option that arranges the alternatives, in order, from the least expensive to the most expensive
Updated On: Jul 17, 2024
- P, Q, R
- R, P, Q
- R, Q, P
- Q,R,P
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
The correct Answers are (C) :R, Q, P
Was this answer helpful?
0
0
Top Questions on Single and multiple reactions in ideal reactors
- A chemostat with cell recycle is shown in the figure. The feed flow rate and culture volume are \( F = 75 \) L/h and \( V = 200 \) L, respectively. The glucose concentration in the feed \( C_{S0} = 15 \) g/L. Assume Monod kinetics with specific cell growth rate \(\mu_g=\)\( \frac{1}{C_c} \frac{dC_c}{dt} = \frac{\mu_m C_S}{K_s + C_S} \),, where \( \mu_m = 0.25 \) h\(^{-1}\) and \( K_s = 1 \) g/L. Assume maintenance, and death rates to be zero, input feed to be sterile (\( C_{S0} = 0 \)), and steady-state operation. The glucose concentration in the recycle stream, \( C_{S1} \), in g/L, rounded off to 1 decimal place, is ____.
- GATE CH - 2024
- Chemical Reaction Engineering
- Single and multiple reactions in ideal reactors
- A first-order liquid phase reaction \( A \rightarrow B \) is conducted in two isothermal plug flow reactors (PFRs) of volume 1 m\(^3\) each, connected in series. The feed flow rate and concentration of A to the first reactor are 10 m\(^3\) h\(^{-1}\) and 1 kmol m\(^{-3}\), respectively. At steady-state, the concentration of A at the exit of the second reactor is 0.2 kmol m\(^{-3}\). If the two PFRs are replaced by two equal-volume continuously stirred tank reactors (CSTRs) to achieve the same overall steady-state conversion, the volume of each CSTR, in m\(^3\), is:
- GATE CH - 2024
- Chemical Reaction Engineering
- Single and multiple reactions in ideal reactors
- The residence time distribution, \( E \), for a non-ideal flow reactor is provided in the figure. A first-order liquid phase reaction with a rate constant of 0.2 min\(^{-1}\) is conducted in the reactor. If the inlet reactant concentration is 2 mol L\(^{-1}\), the reactant concentration (in mol L\(^{-1}\)) in the exit stream is
- GATE CH - 2024
- Chemical Reaction Engineering
- Single and multiple reactions in ideal reactors
- Consider the reaction \(N_2(g) + 3H_2(g)\) \(\rightleftharpoons\)\(2NH_3(g)\) in a continuous flow reactor under steady-state conditions. The component flow rates at the reactor inlet are \( F^0_{{N2}} = 100 \) mol s\(^{-1}\), \( F^0_{{H2}} = 300 \) mol s\(^{-1}\), and \( F^0_{\text{inert}} = 1 \) mol s\(^{-1}\). If the fractional conversion of \( {H2} \) is 0.60, the outlet flow rate of \( {N2} \), in mol s\(^{-1}\), rounded off to the nearest integer, is ___
- GATE CH - 2024
- Chemical Reaction Engineering
- Single and multiple reactions in ideal reactors
- In a 400 KV Network, 360 KV is recorded at a 400KV Bus. The reactive power absorbed by stunt reactor rated for 50M VAR. 400KV connected at a BUS is
- CUET (PG) - 2023
- Chemical Reaction Engineering
- Single and multiple reactions in ideal reactors
Questions Asked in GATE CH exam
- Water of density 1000 kg/m³ is pumped at a volumetric flow rate of \( 3.14 \times 10^{-2} \) m³/s through a pipe of inner diameter 10 cm and length 100 m, from a large Reservoir 1 to another large Reservoir 2 at a height of 50 m above Reservoir 1, as shown in the figure. The flow in the pipe is in the turbulent regime with a Darcy friction factor \( f = 0.06 \) and a kinetic energy correction factor \( \alpha = 1 \). Take \( g = 9.8 \) m/s². If all minor losses are negligible and the pump efficiency is 100%, the pump power, in kW, rounded off to 2 decimal places, is _____.
- GATE CH - 2024
- Macroscopic friction factors
- Methane combusts with air in a furnace according to the reaction \( \text{CH}_4 + 2\text{O}_2 \rightarrow \text{CO}_2 + 2\text{H}_2\text{O} \). The heat of reaction \( \Delta H_{\text{rxn}} \) is -880 kJ per mol of CH4 and is assumed constant. The furnace is well-insulated, and no side reactions occur. All components behave as ideal gases with a constant molar heat capacity of 44 J mol\(^{-1}\) °C\(^{-1}\). Air is composed of 20 mol% O2 and 80 mol% N2. The air-fuel mixture enters the furnace at 50°C. The methane conversion \( X \) varies with the air-to-methane mole ratio \( r \) as \( X = 1 - 0.1 e^{-2(r-r_s)} \) with \( 0.9 r_s \leq r \leq 1.1 r_s \), where \( r_s \) is the stoichiometric air-to-methane mole ratio. For \( r = 1.05 r_s \), the exit flue gas temperature in °C, rounded off to 1 decimal place, is _____.
- GATE CH - 2024
- Heat of reaction
- A solid slab of thickness \( H1 \) is initially at a uniform temperature \( T0 \). At time \( t = 0 \), the temperature of the top surface at \( y = H1 \) is increased to \( T1 \), while the bottom surface at \( y = 0 \) is maintained at \( T0 \) for \( t \geq 0 \). Assume heat transfer occurs only in the \( y \)-direction, and all thermal properties of the slab are constant. The time required for the temperature at \( y = \frac{H1}{2} \) to reach 99% of its final steady value is \( T1 \). If the thickness of the slab is doubled to \( H2 = 2H1 \), and the time required for the temperature at \( y = \frac{H2}{2} \) to reach 99% of its final steady value is \( T2 \), then \( \frac{T2}{T1} \) is .
- GATE CH - 2024
- Heat Transfer
- The temperatures of two large parallel plates of equal emissivity are 900 K and 300 K. A reflection radiation shield of low emissivity and negligible conductive resistance is placed parallelly between them. The steady-state temperature of the shield, in K, is
- GATE CH - 2024
- Heat Transfer
- Consider a vapour-liquid mixture of components A and B that obeys Raoult's law. The vapour pressure of A is half that of B. The vapour phase concentrations of A and B are 3 mol m\(^{-3}\) and 6 mol m\(^{-3}\), respectively. At equilibrium, the ratio of the liquid phase concentration of A to that of B is:
- GATE CH - 2024
- Phase equilibria
View More Questions