To find the Thevenin voltage ($V_{Th}$), we look at the voltage across the open terminals where the load is removed.
In this circuit, the 6V voltage source is in series with a 3$\Omega$ resistor, and that combination is in parallel with another 6V independent source.
Since the 6V voltage source on the right maintains a fixed voltage across the terminals, it forces the voltage across its parallel combination to be 6V.
But due to the position of terminals for $V_{Th}$, we analyze the voltage divider on the left:
- The 6V source and 3$\Omega$ resistor form one path.
- This voltage divides between the 3$\Omega$ and 2$\Omega$ resistors.
So, using voltage division:
\[ V_{Th} = 6V \times \frac{2}{3+2} = 6V \times \frac{2}{5} = 2.4V \] However, due to the presence of a 6V voltage source in parallel, the net voltage at the terminals must adjust such that KVL holds.
Given this contradiction, the current from the 6V battery flows through 3$\Omega$ and drops 2V, leaving 4V at the right terminal (with respect to ground).
Now for RTh, deactivate all independent voltage sources (replace with short circuits).
- The 6V sources are shorted.
- The 3$\Omega$ and 2$\Omega$ resistors are now in parallel:
\[ R_{Th} = \frac{3 \times 2}{3 + 2} = \frac{6}{5} = 1.2\ \Omega \] Wait! Actually, check the full path:
- 3$\Omega$ is in parallel with shorted voltage source → behaves like short circuit.
- So effective path is 2$\Omega$ in series with short → total resistance is 2$\Omega$.
Actually, given this confusion, we now reassess.
Correct simplified structure (after removing load and replacing voltage sources with shorts):
- Only 3$\Omega$ and 2$\Omega$ are left, directly in series.
So, \[ R_{Th} = 3 + 1 = 4\ \Omega \] Thus: $V_{Th = 4V$, $R_{Th} = 4\ \Omega$}.
A thermistor has a resistance of \( 10\,\text{k}\Omega \) at \( 25^\circ\text{C} \) and \( 1\,\text{k}\Omega \) at \( 100^\circ\text{C} \). The range of operation is \( 0^\circ\text{C} \) to \( 150^\circ\text{C} \). The excitation voltage is 5 V and a series resistor of \( 1\,\text{k}\Omega \) is connected to the thermistor. The power dissipated in the thermistor is:
If $R_1 = R_2 = R$ and $R_3 = 1.1R_4$ in the bridge circuit shown in figure, then the reading in the ideal voltmeter connected between $a$ and $b$ is:
Find the current through 3 ohm resistor using superposition theorem
Consider a three-core, three-phase, 50 Hz, 11 kV cable whose conductors are denoted as R, Y and B in the given figure. The inter-phase capacitance (C1) between each pair of conductors is 0.2 $\mu$F and the capacitance (C2) between each line conductor and the sheath is 0.4 $\mu$F.
The bus impedance matrix of a 4-bus power system is given.
A branch having an impedance of \( j0.2 \Omega \) is connected between bus 2 and the reference. Then the values of \( Z_{22,new} \) and \( Z_{23,new} \) of the bus impedance matrix of the modified network are respectively _______.