Question:
A horizontal beam of length 1200 mm is pinned at the left end and is resting on the roller at the other end as shown in the figure. A linearly varying distributed load is applied on the beam. The magnitude of maximum bending moment acting on the beam is _____ Nm (Round off to one decimal place)
A horizontal beam of length 1200 mm is pinned at the left end and is resting on the roller at the other end as shown in the figure. A linearly varying distributed load is applied on the beam. The magnitude of maximum bending moment acting on the beam is _____ Nm (Round off to one decimal place)
Updated On: Jan 18, 2025
Hide Solution
Verified By Collegedunia
Correct Answer: 9
Solution and Explanation
The correct answer is 9.
Was this answer helpful?
0
5
Top Questions on Shear force and bending moment diagrams
- A horizontal beam of length 1200mm is pinned at the left end and is resting on a roller at the other end as shown in the figure. A linearly varying distributed load is applied on the beam. The magnitude of maximum bending moment acting on the beam is _____N.m. (round off to 1 decimal place)
- GATE Metallurgy - 2024
- Applied Mechanics and Design
- Shear force and bending moment diagrams
Questions Asked in GATE Metallurgy exam
- A set of jobs U, V, W, X, Y, Z arrive at time t = 0 to a production line consisting of two workstations in series. Each job must be processed by both workstations in sequence (i.e., the first followed by the second). The process times (in minutes) for each job on each workstation in the production line are given below.
Job U V W X Y Z Workstation 1 5 7 3 4 6 8 Workstation 2 4 6 6 8 5 7
The sequence in which the jobs must be processed by the production line if the total makespan of production is to be minimized is- GATE Metallurgy - 2024
- Principles of non-traditional machining processes
- A ram in the form of a rectangular body of size l=9m and b=2m is suspended by two parallel ropes of lengths 7m. Assume the center-of-mass of the body is at its geometric center and g = 9.81m/s2. For striking the object P with a horizontal velocity of 5m/s, what is the angle θ with the vertical from which the ram should be released from rest?
- GATE Metallurgy - 2024
- Forces on submerged bodies
- In the pipe network shown in the figure, all pipes have the same cross-section and can be assumed to have the same friction factor. The pipes connecting points W, N, and S with point J have an equal length L. The pipe connecting points J and E has a length 10L. The pressures at the ends N, E, and S are equal. The flow rate in the pipe connecting W and J is Q. Assume that the fluid flow is steady, incompressible, and the pressure losses at the pipe entrance and junction are negligible. Consider the following statements:
I: The flow rate in pipe connecting J and E is \(\frac{Q}{21}\).
II: The pressure difference between J and N is equal to the pressure difference between J and E.
Which one of the following options is CORRECT?
- GATE Metallurgy - 2024
- Basics of compressible fluid flow
- The allowance provided to a pattern for easy withdrawal from a sand mold is
- GATE Metallurgy - 2024
- Different types of castings, design of patterns, moulds and cores
- A band brake shown in the figure has a coefficient of friction of 0.3. The band can take a maximum force of 1.5 kN. The maximum braking force (F) that can be safely applied is _____N (rounded off to the nearest integer).
- GATE Metallurgy - 2024
- Friction and its applications including rolling friction, belt-pulley, brakes, screw jack,etc
View More Questions