Question:
A circuit that uses an amplifier with passive filter elements is called as a(n)
A circuit that uses an amplifier with passive filter elements is called as a(n)
Show Hint
In signal processing, active filters are often used when amplifiers are combined with passive components to control frequency response.
Updated On: May 5, 2025
- Relaxation oscillator
- Signal generator
- Differential amplifier
- Active filter
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
A circuit that uses an amplifier along with passive filter elements (such as resistors, capacitors, and inductors) is called an **active filter**. Active filters use amplifiers to enhance the filtering capability, often used to process analog signals and remove unwanted frequencies. Therefore, the correct answer is option (4).
Was this answer helpful?
0
0
Top Questions on Digital Signal Processing
- Let $x(t)=\cos(10\pi t)+\cos(30\pi t)$ be sampled at $20$ Hz and reconstructed using an ideal low–pass filter with cut-off frequency of $20$ Hz. The frequency/frequencies present in the reconstructed signal is/are
- OJEE - 2025
- Electronics Engineering
- Digital Signal Processing
- A modulated signal is $y(t) = m(t)\cos(40000\pi t)$, where the baseband signal $m(t)$ has frequency components less than $5$ kHz only. The minimum required rate (in kHz) at which $y(t)$ should be sampled to recover $m(t)$ is
- OJEE - 2025
- Electronics Engineering
- Digital Signal Processing
- Consider the signal $x(t) = \cos(6\pi t) + \sin(8\pi t)$, where $t$ is in seconds. The Nyquist sampling rate (in samples/second) for the signal $y(t) = x(2t + 5)$ is
- OJEE - 2025
- Electronics Engineering
- Digital Signal Processing
A continuous time periodic signal \( x(t) \) is given by: \[ x(t) = 1 + 2\cos(2\pi t) + 2\cos(4\pi t) + 2\cos(6\pi t) \] If \( T \) is the period of \( x(t) \), then evaluate: \[ \frac{1}{T} \int_0^T |x(t)|^2 \, dt \quad {(round off to the nearest integer).} \]
- GATE EE - 2025
- Signals and Systems
- Digital Signal Processing
- Consider a continuous-time signal \[ x(t) = -t^2 \left\{ u(t+4) - u(t-4) \right\} \] where \( u(t) \) is the continuous-time unit step function. Let \( \delta(t) \) be the continuous-time unit impulse function. The value of \[ \int_{-\infty}^{\infty} x(t)\delta(t+3) \, dt \] is:
- GATE EE - 2025
- Signals and Systems
- Digital Signal Processing
View More Questions
Questions Asked in AP PGECET exam
- The absolute humidity of air at 101.325 kPa is measured to be 0.02 kg of water per kg of dry air. Then the partial pressure of water vapour in the air is:
- AP PGECET - 2025
- Thermodynamics
- If the vapour pressure at two temperatures of a solid phase in equilibrium with its liquid phase is known, then the latent heat of fusion can be calculated by the:
- AP PGECET - 2025
- Thermodynamics
- 1 mole of Argon gas is heated at constant pressure from 200 K to 600 K.
If \( C_p = 4\ \text{cal} \cdot \text{deg}^{-1} \cdot \text{mol}^{-1} \), then the change in entropy will be:
(Given \( \ln 3 = 1.09 \))
- AP PGECET - 2025
- Thermodynamics
- The minimum amount of work required to operate a refrigerator which removes 1000 Cal heat at $0^\circ$C and rejects at $50^\circ$C will be:
- AP PGECET - 2025
- Thermodynamics
- The entropy of single crystalline Silicon at absolute zero will be:
- AP PGECET - 2025
- Thermodynamics
View More Questions