Question:
A circuit that removes all the positive parts of the input signal is a
A circuit that removes all the positive parts of the input signal is a
Show Hint
Wave Shaping Circuits. Clippers limit amplitude. Clampers shift DC level. Positive clipper removes signal portions above a reference level. Negative clipper removes portions below a reference level.
Updated On: May 6, 2025
- Positive clipper
- Positive clamper
- Negative clipper
- Positive voltage doubler
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
- Clippers are circuits that limit or "clip" the voltage swing of a signal, removing parts above or below a certain reference level
A circuit removing positive parts is a positive clipper
- Clampers add a DC offset to a signal, shifting its baseline
- Voltage doublers are rectifier circuits that increase DC voltage
Since the circuit removes the positive portions of the signal, it is performing positive clipping
A circuit removing positive parts is a positive clipper
- Clampers add a DC offset to a signal, shifting its baseline
- Voltage doublers are rectifier circuits that increase DC voltage
Since the circuit removes the positive portions of the signal, it is performing positive clipping
Was this answer helpful?
0
0
Top Questions on Analog Electronics
- In JFET, drain current is primarily controlled by ________.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Analog Electronics
The MOSFET circuit implements the function.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Analog Electronics
- The gate voltage in a JFET at which drain current becomes zero is called _______.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Analog Electronics
- The drain current in a JFET is given by:
- AP PGECET - 2025
- Electronics and Communication Engineering
- Analog Electronics
- For operating an n-channel JFET in pinch-off region, the condition needed to be satisfied is ________.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Analog Electronics
View More Questions
Questions Asked in AP PGECET exam
If $R_1 = R_2 = R$ and $R_3 = 1.1R_4$ in the bridge circuit shown in figure, then the reading in the ideal voltmeter connected between $a$ and $b$ is:
- AP PGECET - 2025
- Electrical and Electronic Measurements
In the below circuit, the value of $V_1$ is:
- AP PGECET - 2025
- Electrical and Electronic Measurements
- AP PGECET - 2025
- Electrical and Electronic Measurements
- When testing a coil having a resistance of \( 10\,\Omega \), resonance occurred when the oscillator frequency was \( 10\,\text{MHz} \) and the rotating capacitor was set at \( \dfrac{500}{2\pi}\,\text{pF} \). The effective value of the Q of the coil is:
- AP PGECET - 2025
- Electronics
- The open-loop voltage gain of an amplifier is 240. The noise level in the output without feedback is 100 mV. If a negative feedback with \( \beta = \dfrac{1}{60} \) is used, the noise level in the output will be:
- AP PGECET - 2025
- Electronics
View More Questions