A choke is preferred to a resistance for limiting current in AC circuit because
- choke is cheap
- there is no wastage of power
- choke is compact in size
- choke is a good absorber of heat
The Correct Option is B
Solution and Explanation
Top Questions on Alternating current
- An alternating current is given by \[ I = I_A \sin \omega t + I_B \cos \omega t. \] The r.m.s. current will be:
- JEE Main - 2025
- Physics
- Alternating current
- A resistance of \( 20 \Omega \) is connected to a source of an alternating potential \( V = 200 \sin(10\pi t) \). If \( t \) is the time taken by the current to change from the peak value to the rms value, then \( t \) is (in seconds):
- AP EAPCET - 2024
- Physics
- Alternating current
- A resistor of resistance \( R \), inductor of inductive reactance \( 2R \) and a capacitor of capacitive reactance \( X_C \) are connected in series to an A.C. source. If the series LCR circuit is in resonance, then the power factor of the circuit and the value \( X_C \) are respectively:
- AP EAPCET - 2024
- Physics
- Alternating current
- An alternating emf \( E = 110\sqrt{2} \sin 100t \, \text{volt} \) is applied to a capacitor of \( 2\mu\text{F} \), the rms value of current in the circuit is \(\dots\) \(\text{mA}\).
- JEE Main - 2024
- Physics
- Alternating current
- A coil of negligible resistance is connected in series with \(90 \, \Omega\) resistor across \(120 \, \text{V}, \, 60 \, \text{Hz}\) supply. A voltmeter reads \(36 \, \text{V}\) across resistance. Inductance of the coil is:
- JEE Main - 2024
- Physics
- Alternating current
Questions Asked in JCECE exam
- In the figure, the ball P is released from rest, when the spring is at its natural length. For the block Q of mass $ 2{{m}_{0}} $ to leave contact with ground at some stage, the minimum mass of P must be
- JCECE - 2015
- Conservation of energy
- A $ 50\,\Omega $ galvanometer is shunted by a resistance of $ 5\,\Omega . $ The percentage of the total current, which passes through the galvanometer is
- JCECE - 2015
- Current electricity
- The effective resistance across the points P and Q is
- JCECE - 2015
- Current electricity
- A disc of radius a and mass m is pivoted at the rim and is set in small oscillation. If a simple pendulum have the same period as that of the disc, then the length of the simple pendulum should be
- JCECE - 2015
- Oscillations
- An elliptically shaped ring of dimensions shown in figure just touches, the horizontal surface of a liquid of surface tension S. The force required to pull the ring away from the liquid surface is
- JCECE - 2015
- Surface tension
Concepts Used:
Alternating Current
An alternating current can be defined as a current that changes its magnitude and polarity at regular intervals of time. It can also be defined as an electrical current that repeatedly changes or reverses its direction opposite to that of Direct Current or DC which always flows in a single direction as shown below.
Alternating Current Production
Alternating current can be produced or generated by using devices that are known as alternators. However, alternating current can also be produced by different methods where many circuits are used. One of the most common or simple ways of generating AC is by using a basic single coil AC generator which consists of two-pole magnets and a single loop of wire having a rectangular shape.
Application of Alternating Current
AC is the form of current that are mostly used in different appliances. Some of the examples of alternating current include audio signal, radio signal, etc. An alternating current has a wide advantage over DC as AC is able to transmit power over large distances without great loss of energy.