Question:
A buck regulator has an input voltage of 16V and the required output voltage is 4V. What is the duty cycle of the regulator?
A buck regulator has an input voltage of 16V and the required output voltage is 4V. What is the duty cycle of the regulator?
Updated On: Mar 21, 2024
- \(\frac{1}{16}\)
- \(\frac{1}{8}\)
- \(\frac{1}{4}\)
- \(\frac{3}{4}\)
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
The correct option is (C):\(\frac{1}{4}\) .
Was this answer helpful?
0
0
Top Questions on Measurement of voltage
- PIV of a SCR is 650V. Find out the required Voltage if the safety factor is 2.
- CUET (PG) - 2023
- Electrical and Electronic Measurements
- Measurement of voltage
- The circuit shown in the figure will work as____
- CUET (PG) - 2023
- Electrical and Electronic Measurements
- Measurement of voltage
- What is the maximum output voltage of a 3-ph bridge rectifier supplied with line voltage of 440V?
- CUET (PG) - 2023
- Electrical and Electronic Measurements
- Measurement of voltage
- The classification of transmission lines (T.L)as short. Medium & Long T.L is based upon__
- CUET (PG) - 2023
- Electrical and Electronic Measurements
- Measurement of voltage
- An Op-amp has a slew rate of 5V/us. The largest sine wave output voltage possible at a frequency of 1MHz is____
- CUET (PG) - 2023
- Electrical and Electronic Measurements
- Measurement of voltage
View More Questions
Questions Asked in CUET PG exam
- Find out the degree of the differential equation \(\frac {d^2t}{ds^2}+(\frac {dt}{ds})^2+2t=0\)
- CUET (PG) - 2023
- Differential Equations
- The surface area of the sphere x2 + y2 + z2 = 9 lying inside the cylinder x2 + y2 = 3y is
- CUET (PG) - 2023
- Surface Area of Cube, Cuboid and Cylinder
- The Ombudsman in a newspaper organisation represents the point of view of the ___.
- CUET (PG) - 2023
- Journalism
- The orthogonal trajectories of the family of curves y = \(ax^3\) is
- The minimum distance of the point (3, 4, 12) from the sphere x2 + y2 + z2 = 1 is
- CUET (PG) - 2023
- Coordinate Geometry
View More Questions