A big water drop is formed by the combination of ?n? small water drops of equal radii. The ratio of the surface energy of ?n' drops to the surface energy of big drop is
- $n^2 : 1 $
- $n : 1 $
- $\sqrt{n} : 1 $
- $\sqrt[3]{n} : 1 $
The Correct Option is D
Solution and Explanation
Top Questions on Surface Tension
Consider a water tank shown in the figure. It has one wall at \(x = L\) and can be taken to be very wide in the z direction. When filled with a liquid of surface tension \(S\) and density \( \rho \), the liquid surface makes angle \( \theta_0 \) (\( \theta_0 < < 1 \)) with the x-axis at \(x = L\). If \(y(x)\) is the height of the surface then the equation for \(y(x)\) is: (take \(g\) as the acceleration due to gravity)
- NEET (UG) - 2025
- Physics
- Surface Tension
- A balloon is made of a material of surface tension S and has a small outlet. It is filled with air of density \( \rho \). Initially the balloon is a sphere of radius R. When the gas is allowed to flow out slowly at a constant rate, its radius shrinks as \( r(t) \). Assume that the pressure inside the balloon is \( P(r) \) and is more than the outside pressure (\( P_0 \)) by an amount proportional to the surface tension and inversely proportional to the radius. The balloon bursts when its radius reaches \( r_0 \). Then the speed of gas coming out of the balloon at \( r = R \) is :
- NEET (UG) - 2025
- Physics
- Surface Tension
- Two water drops each of radius \( r \) coalesce to form a bigger drop. If \( T \) is the surface tension, the surface energy released in this process is:
- JEE Main - 2025
- Physics
- Surface Tension
- An air bubble of radius 1.0 mm is observed at a depth of 20 cm below the free surface of a liquid having surface tension \( 0.095 \, \text{J/m}^2 \) and density \( 10^3 \, \text{kg/m}^3 \). The difference between pressure inside the bubble and atmospheric pressure is: Given \( g = 10 \, \text{m/s}^2 \).
- JEE Main - 2025
- Physics
- Surface Tension
- An air bubble of radius 0.1 cm lies at a depth of 20 cm below the free surface of a liquid of density 1000 kg/m\(^3\). If the pressure inside the bubble is 2100 N/m\(^2\) greater than the atmospheric pressure, then the surface tension of the liquid in SI units is (use \(g = 10 \, {m/s}^2\)).
- JEE Main - 2025
- Physics
- Surface Tension
Questions Asked in JEE Advanced exam
The reaction sequence given below is carried out with 16 moles of X. The yield of the major product in each step is given below the product in parentheses. The amount (in grams) of S produced is ____.
Use: Atomic mass (in amu): H = 1, C = 12, O = 16, Br = 80- JEE Advanced - 2025
- Organic Chemistry
Let $ a_0, a_1, ..., a_{23} $ be real numbers such that $$ \left(1 + \frac{2}{5}x \right)^{23} = \sum_{i=0}^{23} a_i x^i $$ for every real number $ x $. Let $ a_r $ be the largest among the numbers $ a_j $ for $ 0 \leq j \leq 23 $. Then the value of $ r $ is ________.
- JEE Advanced - 2025
- binomial expansion formula
- The total number of real solutions of the equation $$ \theta = \tan^{-1}(2 \tan \theta) - \frac{1}{2} \sin^{-1} \left( \frac{6 \tan \theta}{9 + \tan^2 \theta} \right) $$ is
(Here, the inverse trigonometric functions $ \sin^{-1} x $ and $ \tan^{-1} x $ assume values in $[-\frac{\pi}{2}, \frac{\pi}{2}]$ and $(-\frac{\pi}{2}, \frac{\pi}{2})$, respectively.)- JEE Advanced - 2025
- Inverse Trigonometric Functions
Let $ \mathbb{R} $ denote the set of all real numbers. Then the area of the region $$ \left\{ (x, y) \in \mathbb{R} \times \mathbb{R} : x > 0, y > \frac{1}{x},\ 5x - 4y - 1 > 0,\ 4x + 4y - 17 < 0 \right\} $$ is
- JEE Advanced - 2025
- Coordinate Geometry
The center of a disk of radius $ r $ and mass $ m $ is attached to a spring of spring constant $ k $, inside a ring of radius $ R>r $ as shown in the figure. The other end of the spring is attached on the periphery of the ring. Both the ring and the disk are in the same vertical plane. The disk can only roll along the inside periphery of the ring, without slipping. The spring can only be stretched or compressed along the periphery of the ring, following Hooke’s law. In equilibrium, the disk is at the bottom of the ring. Assuming small displacement of the disc, the time period of oscillation of center of mass of the disk is written as $ T = \frac{2\pi}{\omega} $. The correct expression for $ \omega $ is ( $ g $ is the acceleration due to gravity):
- JEE Advanced - 2025
- Waves and Oscillations
Concepts Used:
Surface Tension
The amount of energy required to increase the liquid's surface area by one unit area is known as surface tension. In other words, it is a property of the liquid surface to resist force.
Surface tension is defined as,
The ratio of the surface force F to the length L along which the force acts.
Mathematically, the surface tension formula can be expressed as follows:
T=F/L
Where,
- F is the force per unit length
- L is the length in which force act
- T is the surface tension of the liquid
Read More: Detergents and Surface Tension
Factors affecting surface tension:
- Impurities: The surface tension decreases with the addition of impurities.
- Surfactants: Adding surfactants in liquids lowers the tension of water making it interrupt aside or get susceptible.
- Temperature: The surface tension of a liquid reduces as the temperature rises.
The Unit of Surface Tension:
The SI unit of Surface Tension is Newton per Meter or N/m.