List of top Instrumentation Engineering Questions asked in Andhra Pradesh Post Graduate Engineering Common Entrance Test

The internal resistance of armature should ideally be:
Hot wire anemometer is used to measure:
The electrical output down a thermocouple circuit is detected by using:
A dead weight tester is used for:
Load cells are used for measurement of:
Which of the following is the best method for determining the stability and transient response?
An ideal op-amp has CMRR:
The Bode plot of the transfer function $G(s) = 5$ is:
If the characteristic equation of a closed-loop system is $s^2 + 2s + 2 = 0$, then the system is:
In majority of instruments damping is provided by:
The type denotes the number of:
What determines the light intensity in a CRT?
What is the vector address of RST 6.5 interrupt?
How many special function registers are there in 8051 microcontroller?
The binary representation of the decimal number 1.375 is
Which of the following controller produces zero offset?
The number of hardware interrupts (which require an external signal to interrupt) present in an 8085 microprocessor are:
What is the maximum addressing capacity of 8085 microprocessor?
A $100\ \Omega$, 1 W resistor and a $800\ \Omega$, 2 W resistor are connected in series. The maximum DC voltage that can be applied continuously to the series circuit without exceeding the power limit of any of the resistors is:
What decides the bit size of 8085 microprocessor?
Which of the following logics possesses highest noise immunity?
For increasing the range of voltmeter, connect a:
A dual-trace CRO has:
Rectifier moving coil instrument responds to:
In electrodynamometer type wattmeter, the inductance of pressure coil produces error. The error is: