List of top Questions asked in Andhra Pradesh Post Graduate Engineering Common Entrance Test

Which of the following correctly describes the composition of Earth’s core?
What is the process called when a parent rock transforms due to heat and pressure without melting?
Which of the following best explains the term "continental shield"?
Which of the following is a framework silicate mineral?
Where is Earth’s core located relative to the surface?

If A $\to$ B has trivial functional dependency, then _______.
 

Which is the candidate key for the relation R(ABCDE) with functional dependencies F=A→BC, B→D, CD→E, E→A?
 

A relation \(R(A,B,C,D)\) with functional dependencies A→B, B→C is in _______ .
 

The minimum number of states in a DFA accepting \( L = \{ w | w \text{ ends with } 01 \} \) over \( \Sigma = \{0, 1\} \) is _______ .

What is the output of the following code fragment? 
int x = 24;} 
printf("%d\n", x); 
printf("%3d %3d\n", x, x);}

In a 4-bit ripple carry adder, the worst-case delay occurs when _______.

Match the following limit test reagents correctly.

A) Arsenic1) Dithizone
B) Lead2) Thioglycolic acid
C) Iron3) Barium chloride
D) Barium4) Mercuric chloride
Which guideline is commonly referred to for method validation in pharmaceutical analysis?
What will be change observed in liquid chromatography with increased mobile phase flow rate?
Which of the following functional group(s) does not show two absorption peaks in IR spectroscopy:
If 10 mL of 0.1 M sulphuric acid solution requires 20 mL of NaOH solution, then the normality of NaOH solution is:
During titration of strong acid with a weak base, which one is correct with respect to conductance?
Which substance is commonly used titrant in iodometric titrations?
Which of the following is correct about robustness and ruggedness in method validation?
Which of the following is a primary standard used in the calibration of spectrophotometers?
Find the correct sentence from the following about accuracy and precision in pharmaceutical analysis.
The errors arising due to use of un-calibrated or improperly calibrated weights are known as:
For the $pH$ range of 2.8 to 4.6, which indicator should be preferred?
The phenomenon called "levelling effect" for weak acids will be observed in ________ solvents.
To obtain the best results in any of the quantitative TLC methods, the spots being used should have \( R_f \) values between _______.