List of top Metallurgical Engineering Questions asked in TS PGECET

Electrodes used in anodizing process are:
Melting rates of electrodes in manual metal arc welding process is mainly governed by the
Which of the following is not a solid state metal joining technique?
Welds made with high heat input will show reduction in
Die casting of aluminium is not done because of the reason that, it is
Skim bob is attached to
Which of the following welding uses consumable electrode?
A tooth paste tube can be produced by
In casting, to promote / provide unidirectional solidification which of the following are used?
A casting defect, which occurs near the ingates as rough lumps on the surface of a casting is known as
Stainless steel is welded using
In two high reversing mill, the rolls used are
The microsegregation observed in casting is called
Hot extrusion of aluminium is done in the temperature range of
Which of the following is an exclusively cold working process?
In cold working of steel
Which of the following is \textbf{not a non-destructive test?}
Forging is accomplished in drop forging by dropping the
Strain ageing is common in
Which of the following has the lowest tensile strength?
Which of the following occupy maximum percentage of powder metallurgy parts distribution in the engineering industry?
Which of the following assumptions is not related to continuous casting?
The objection with the use of ------------- is a tendency for producing a fountain effect in the casting.
The most serious manufacturing defect from fracture toughness point of view is
The primary strengthening mechanism in 70:30 brass is