List of top Civil Engineering Questions asked in Telangana State Post Graduate Engineering Common Entrance Test

The flow rate of a liquid through a pipe is 0.5 m³/s. What is the velocity of the fluid if the pipe has a diameter of 0.1 m?
The ultimate tensile strength of a material is 400 MPa. If the diameter of the wire is 10 mm, what is the maximum force that can be applied to the wire before it breaks?
Determine the moment of inertia of a rectangular beam section with a width of 300 mm and height of 500 mm about its neutral axis.
A thermocouple is used to measure:
The term 'Feng Shui' is associated with:
The modulus of elasticity of concrete is influenced by:
A level when set up 25 m from peg A and 50 m from peg B reads 2.847 on a staff held on A and 3.462 on a staff held on B, keeping the bubble at its centre while reading. If the reduced levels of A and B are 283.665 m and 284.295 m respectively, the collimation error per 100 m is
The design technique, adopted in design of large water supply networks, as an aid to simplify and separate the smaller loops is
The camber prescribed by the I.R.C. for cement concrete or high type bituminous roads in percentage is
In a cable suspension bridge, the cable is assumed to be:
The ratio of passenger car unit of pedal cycle to passenger car unit of car is
If the atmospheric pressure on the surface of an oil tank (sp. gr. 0.8) is $ 0.1 \, \text{kg/cm}^2 $, the pressure at a depth of $ 2.5 \, \text{m} $, is
Wrought iron contains carbon up to
The angle between the direction of star and the direction of earth's axis of rotation is called as
Fixed delay does not depend on which of the following factor?
What is the most commonly used overlay?
The biochemical oxygen demand is computed by
Economic height of a dam is the height corresponding to which
Turbidity of raw water is a measure of
A crop requires 1000 mm of water for a base period of 100 days. The duty of water in hectares per cumec is
Which of the following is not a common use of unit hydrographs?
Bishop's simplified method of slices satisfies
The negative skin friction on a pile develops when
The point where vertical line passing through the perspective centre intersects the plane of the photograph, is known as
The orthogonal projection of the perspective centre on a tilted photograph is called as