Total Station is an equipment used for _________.
Show Hint
- measurement of rainfall intensity
- noise level measurement
- air quality measurement
- determination of coordinates of unknown points relative to a known coordinate
The Correct Option is D
Solution and Explanation
A Total Station is an electronic/optical instrument used in surveying. It is primarily used for determining the coordinates of unknown points relative to a known coordinate, using angle and distance measurements. Total Stations are extensively used in civil engineering, construction, and geodesy.
Thus, the correct answer is (D) determination of coordinates of unknown points relative to a known coordinate.
Top Questions on Economics
Match the following Curves in Group-I with their corresponding uses in Group-II.
- As per the Right to Fair Compensation and Transparency in Land Acquisition, Rehabilitation and Resettlement Act, 2013, the ________ determines the _________ for compensation for land acquisition.
- _________ refers to the benefits when industries/firms cluster together resulting in reduced production cost, improved availability of skilled labor, and increased flow of information and knowledge sharing.
- Which of the following statements best describes the nature of the National Automated Clearing House (NACH) implemented by the National Payment Corporation of India (NPCI)?
- What is the full form of LIC?
Questions Asked in GATE AR exam
- A 24 cm line AB is vertically standing on a horizontal plane. The station point is located 18 cm above ground and 15 cm in front of the line AB. The picture plane is located in between the line AB and station point perpendicular to the sight line. The distance between the picture plane and the station point is 9 cm. The height of the perspective view of the line AB is ________cm. (rounded off to one decimal place)
- GATE AR - 2025
- Height & Distance
A four-arm uncontrolled un-signaled urban intersection of both-way traffic is illustrated in the figure. Vehicles approaching the intersection from the directions A, B, C, and D can move to either left, right, or continue in straight direction. No U-turn is allowed. In the given situation, the maximum number of vehicular crossing conflict points for this intersection is _________ (answer in integer)
- GATE AR - 2025
- Traffic survey methods, Traffic flow Analysis
An individual chooses a transport mode for a particular trip based on three attributes i.e., cost of journey (X), In-vehicle travel time to reach destination (Y), and Out-of-vehicle time taken to access mode at respective stops (Z). The values for these attributes for three modes Rail, Bus and Para-transit are given in the table. If the general utility (U) equation is \( U = - 0.5 \times X - 0.3 \times Y - 0.4 \times Z \), using the Logit model, the estimated probability of choosing Bus is _________ (rounded off to two decimal places).
- GATE AR - 2025
- Transportation
- The spot speeds (in km/h) of eight vehicles in a traffic stream are 42, 52, 56, X, 53, 62, 65, and 48. X is the spot speed of the fourth vehicle. The Time Mean Speed of the traffic stream is 56.25 km/h. After determining the value of X, the calculated Space Mean Speed of the traffic stream is _________ km/h. (rounded off to two decimal places)
- GATE AR - 2025
- Traffic survey methods, Traffic flow Analysis
- Which of the following is/are the characteristics of urban agglomeration as per the Census of India, 2011?
- GATE AR - 2025
- Urban Planning