>
Exams
>
Electrical Engineering
>
Control Systems
>
the value of k where root locus cuts the j axis in
Question:
The value of \( k \), where root locus cuts the jω axis in plotting root locus, is calculated by
Show Hint
The jω crossing in root locus is found using the condition \( \frac{dK}{ds} = 0 \).
TS PGECET - 2024
TS PGECET
Updated On:
May 23, 2025
taking \( \frac{dK}{ds} = 0 \)
where the first asymptote cuts the jω axis
Bode Plot
Routh-Hurwitz method
Hide Solution
Verified By Collegedunia
The Correct Option is
A
Solution and Explanation
On the root locus, the point where it crosses the jω-axis is the point where \( \frac{dK}{ds} = 0 \). This condition helps in identifying the breakaway or entry points on the imaginary axis.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Control Systems
The Block diagram for a control system is shown below:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
Bode diagram is a plot of (AR is amplitude ratio; $\omega$ is frequency factor and $\phi$ is phase angle):
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
The transfer function of a PID controller is:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
The characteristic equation for the system is
\[ s^3 + 9s^2 + 26s + 12(2 + K_c) = 0 \]
Using Routh test, the value of Kc that will keep the system stable is:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
The Bode diagram stability criterion is applicable when:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
View More Questions
Questions Asked in TS PGECET exam
In which year was the Earth Summit (Rio Conference) held?
TS PGECET - 2025
Environmental pollution
View Solution
A bag contains 3 red and 2 blue balls. Two balls are drawn without replacement. What is the probability that both are red?
TS PGECET - 2025
Probability
View Solution
Which of the following techniques is primarily used for the synthesis of carbon nanotubes?
TS PGECET - 2025
Strength of Materials
View Solution
The top-down approach in nanofabrication refers to:
TS PGECET - 2025
Metrology and Inspection
View Solution
The term "carrying capacity" refers to:
TS PGECET - 2025
Sustainable Development
View Solution
View More Questions