Question:
The Tin coating is measured by using
The Tin coating is measured by using
Show Hint
Elcometers provide precise coating thickness measurements for quality control in metal industries.
Updated On: Feb 27, 2025
- Viscometer
- Hygrometer
- Elcometer
- Luxmeter
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
An Elcometer is used to measure the thickness of tin coatings. It works through non-destructive techniques like magnetic induction or eddy current methods to ensure proper coating application and to check if the thickness meets the required specifications.
Was this answer helpful?
0
0
Top Questions on Printing and Packaging Materials
- Which of the following packaging materials is used for packing of fruits?
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- VCI films are used to avoid __________ of automotive packaging
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- Which of the following covers is a cover made from paper or paper fiber material with greater substance than that used for the body of the book?
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- The paper-based substrate is called as
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- Which of the following is the package commonly used for packing tablets, capsules, and electronic gadgets?
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
View More Questions
Questions Asked in TANCET exam
- What is in this sequence? Y, V, S, P, ___
- The faces in a tetragon are
- TANCET - 2024
- Crystallography
- What letter replaces the question mark?
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
View More Questions