>
Exams
>
Power Systems
>
Power System Stability
>
the sequence components of the fault current in a
Question:
The Sequence components of the fault current in a system are as follows:
\(I_{positive}\)
= j1.5p.u
\(I_{negative}\)
= -j 0.5 p.u
\(I_{zero}\)
= -j 1 p.u
The type of fault in a power system is_____
CUET (PG) - 2023
CUET (PG)
Updated On:
Mar 21, 2024
LG
LL
LLG
LLLG
Hide Solution
Verified By Collegedunia
The Correct Option is
C
Solution and Explanation
The correct option is (C):LLG .
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Power System Stability
Which of the following types of faults does a bus differential relay NOT effectively detect?
AP PGECET - 2024
Electrical Engineering
Power System Stability
View Solution
In a 220kV system, the inductance and capacitance up to the circuit breaker location are 25 mH and 0.025 micro Farads. The value of the resistor required to be connected across the breaker contacts which will give no transient oscillations is:
AP PGECET - 2024
Electrical Engineering
Power System Stability
View Solution
The Y-bus matrix of a 100-bus interconnected system is 90% sparse. Hence the number of transmission lines in the system must be:
AP PGECET - 2024
Electrical Engineering
Power System Stability
View Solution
In a multi-machine interconnected power system, subsequent to a 3-phase fault, the transient stability is examined by:
AP PGECET - 2024
Electrical Engineering
Power System Stability
View Solution
For a given power system, its zero and maximum regulation will occur at the impedance angle of:
AP PGECET - 2024
Electrical Engineering
Power System Stability
View Solution
View More Questions
Questions Asked in CUET PG exam
A bought an article at a certain price and sold it at 10% profit. B bought the same article at a price 10% lesser than A and sold it at ₹18 lesser than A. B's gain percentage in this deal is 20%. At what price B bought the article?
CUET (PG) - 2025
Profit and Loss
View Solution
The traffic lights at three different road crossings change after every 48 seconds, 72 seconds and 108 seconds respectively. If they all change simultaneously at 8:20:00 hours, then at what time will they again change simultaneously?
CUET (PG) - 2025
Quantitative Aptitude
View Solution
In terracotta which materials are mainly used to build strong clay
(A) Grog
(B) Metal
(C) Cotton
(D) Stone
Choose the correct answer from the options given below:
CUET (PG) - 2025
Ceramics and Pottery
View Solution
Under the Protection of Women from Domestic Violence Act, 2005, the definition of "domestic relationship" includes:
CUET (PG) - 2025
Social Legislation
View Solution
The mezzotint method invented by Lindberg Von Sleigen is a version of:
CUET (PG) - 2025
Printmaking Techniques
View Solution
View More Questions