Question:
The process of exposing the test specimen to a standard condition is known as
The process of exposing the test specimen to a standard condition is known as
Show Hint
Conditioning standardizes test conditions for accurate and repeatable results.
Updated On: Feb 27, 2025
- Conditioning
- Calibrating
- Characterizing
- None of the above
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
Conditioning refers to the process of exposing a test specimen to specific environmental conditions, such as temperature and humidity, before conducting tests to ensure consistent and reliable results. This process is essential to ensure that the material is in a stable state before testing.
Was this answer helpful?
0
0
Top Questions on Printing and Packaging Materials
- Which of the following packaging materials is used for packing of fruits?
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- VCI films are used to avoid __________ of automotive packaging
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- Which of the following covers is a cover made from paper or paper fiber material with greater substance than that used for the body of the book?
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- The paper-based substrate is called as
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
- Which of the following is the package commonly used for packing tablets, capsules, and electronic gadgets?
- TANCET - 2024
- Printing Technology
- Printing and Packaging Materials
View More Questions
Questions Asked in TANCET exam
- What letter replaces the question mark?
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
- The speed of a motor boat in still water is 7km/hr. If the speed of the motor boat against the stream is 5 km/hr, what is the speed of the stream?
- TANCET - 2024
- Time, Speed and Distance
A closed-loop system has the characteristic equation given by: $ s^3 + k s^2 + (k+2) s + 3 = 0 $.
For the system to be stable, the value of $ k $ is:- TANCET - 2024
- Microprocessors
View More Questions