Question:
The instruction XLAT in 8086 microprocessor is used to
The instruction XLAT in 8086 microprocessor is used to
Show Hint
The XLAT instruction is commonly used for data translation tasks in the 8086 microprocessor.
Updated On: Feb 7, 2025
- Translate a byte in AL using a table index
- Transfer data from source to destination
- Push the contents of specified source onto the stack
- Exchange the contents of source with destination
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
- The XLAT instruction translates the contents of the AL register using a lookup table at the address indexed by BX.
Conclusion: The correct operation is described by option (a).
Conclusion: The correct operation is described by option (a).
Was this answer helpful?
0
0
Top Questions on Microprocessors
- Loop transfer function of a feedback system is: \[ G(s)H(s) = \frac{10}{s - 2} \] Assume the Nyquist contour in the clockwise direction. Then the Nyquist plot of \( G(s) \) encircles \(-1 + j0\):
- TANCET - 2024
- Electrical Engineering
- Microprocessors
- A closed-loop system has the characteristic equation given by: \[ s^3 + k s^2 + (k+2) s + 3 = 0 \] For the system to be stable, the value of \( k \) is:
- TANCET - 2024
- Electrical Engineering
- Microprocessors
- A system has two zeros and four poles. Then two asymptotes in the root loci plane move towards infinity along:
- TANCET - 2024
- Electrical Engineering
- Microprocessors
- The steady-state error due to unit acceleration input for a type 2 system is:
- TANCET - 2024
- Electrical Engineering
- Microprocessors
- The Impulse Response of an initially relaxed linear system is \( e^{-2t}u(t) \). To produce a response of \( te^{-2t}u(t) \), the input should be:
- TANCET - 2024
- Electrical Engineering
- Microprocessors
View More Questions
Questions Asked in TANCET exam
- The centrifugal force (N) acting on a material mass 2g present at the tip of a beater of radius 25 cm rotating at 600 rpm is
- TANCET - 2024
- Yarn Engineering
- Select the correct match
- TANCET - 2024
- Yarn Engineering
- Two yarns of count X each are doubled and plied. The ratio of resultant count of two ply yarn expressed in tex system and Ne system is_______. Neglect contraction due to twist.
- TANCET - 2024
- Yarn Engineering
- A reed has 15 dents/cm, and the warp is drawn in two ends per dent. If the finished fabric is 1.4 m wide compared with 1.47 m wide in the reed, what is the finished fabric sett?
- TANCET - 2024
- Fabric Engineering
- Among the following systems of drafting, the objective of which is to reduce the friction between adjacent warp ends?
- TANCET - 2024
- Fabric Engineering
View More Questions