The given circuit has two ideal diodes connected as shown in the figure below. The current flowing through the resistance \(R_1\) will be
- 2.5 A
- 10.0 A
- 1.43 A
- 3.13 A
The Correct Option is A
Solution and Explanation
Diode Circuit Analysis
The diode D₁ will be in reverse bias, so it will block the current and diode D₂ will be in forward bias, so it will pass the current.
Current Calculation:
Given that the total resistance in the circuit is:
- Resistance of the first resistor = 2Ω
- Resistance of the second resistor = 2Ω
- Total resistance (R) = 2Ω + 2Ω = 4Ω
Using Ohm's law, the current i is:
i = V / R = 10V / 4Ω = 2.5A
Therefore, the current passing through the circuit is 2.5 A.
Top Questions on Resistance
The graph between variation of resistance of a wire as a function of its diameter keeping other parameters like length and temperature constant is
- KCET - 2025
- Physics
- Resistance
- A current of 2 A flows through a conductor with a resistance of 5 \(\Omega\). Calculate the potential difference across the conductor.
- MHT CET - 2025
- Physics
- Resistance
- The S.I. unit of electrical resistance is
- TS POLYCET - 2024
- Physics
- Resistance
- Calculate the resultant resistance in the following circuit.
- TS POLYCET - 2024
- Physics
- Resistance
- Formula for specific resistance is
- TS POLYCET - 2024
- Physics
- Resistance
Questions Asked in NEET exam
In a Vernier caliper, \(N+1\) divisions of vernier scale coincide with \(N\) divisions of main scale. If 1 MSD represents 0.1 mm, the vernier constant (in cm) is:
- NEET (UG) - 2024
- Units, Dimensions and Measurements
- In an ecosystem if the Net Primary Productivity (NPP) of first trophic level is 100x (kcal m-2)yr-1, what would be the GPP (Gross Primary Productivity) of the third trophic level of the same ecosystem?
- NEET (UG) - 2024
- Ecosystems
- Two bodies A and B of same mass undergo completely inelastic one dimensional collision. The body A moves with velocity v1 while body B is at rest before collision. The velocity of the system after collision is v2. The ratio v1 : v2 is :
- NEET (UG) - 2024
- Average Velocity and Instantaneous Velocity
- A bob is whirled in a horizontal plane by means of a string with an initial speed of ω rpm. The tension in the string is T. If speed becomes 2ω while keeping the same radius, the tension in the string becomes:
Identify the major product C formed in the following reaction sequence:
- NEET (UG) - 2024
- Chemical Reactions
Concepts Used:
Resistance
Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.
R=V/I
In this case,
v = Voltage across its ends
I = Current flowing through it
All materials resist current flow to some degree. They fall into one of two broad categories:
- Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
- Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.
Resistance measurements are normally taken to indicate the condition of a component or a circuit.
- The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
- The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.