Question:
The following are the selection characteristics considered while choosing a material for brake lining. Identify the incorrect characteristic.
The following are the selection characteristics considered while choosing a material for brake lining. Identify the incorrect characteristic.
Updated On: Feb 27, 2025
- It should have low wear rate
- It should have low coefficient of friction with maximum fading
- It should have high heat dissipation capacity
- It should not be affected by moisture and oil
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
Brake linings should have a high coefficient of friction to ensure efficient braking and should resist fading under high temperatures.
Was this answer helpful?
0
0
Top Questions on Material Science
- _________materials are those materials that are made of polymers that are joined by chemical bonds, acquiring a slightly cross linked structure.
- CBSE CLASS XII - 2025
- Design
- Material Science
- Which of the following types of penetrant is most commonly used for detecting very fine surface cracks in non-porous materials?
- AP PGECET - 2025
- Metallurgical Engineering
- Material Science
- Which of the following is the major drawback of using X-rays compared to gamma rays for inspecting thick materials in Radiography Test?
- AP PGECET - 2025
- Metallurgical Engineering
- Material Science
- Fiber strengthening is effective in:
- AP PGECET - 2025
- Metallurgical Engineering
- Material Science
- The strength of grain boundary and grains are equal:
- AP PGECET - 2025
- Metallurgical Engineering
- Material Science
View More Questions
Questions Asked in TANCET exam
- What is in this sequence? Y, V, S, P, ___
- The faces in a tetragon are
- TANCET - 2024
- Crystallography
- What letter replaces the question mark?
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
View More Questions