Question:
Strength of the tool cutting edge in orthogonal cutting in comparison to that of the oblique cutting is:
Strength of the tool cutting edge in orthogonal cutting in comparison to that of the oblique cutting is:
Updated On: Mar 21, 2024
- the same
- more
- less
- dependent on the tool material
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
The correct option is (C): less
Was this answer helpful?
0
0
Questions Asked in CUET PG exam
- Find out the degree of the differential equation \(\frac {d^2t}{ds^2}+(\frac {dt}{ds})^2+2t=0\)
- CUET (PG) - 2023
- Differential Equations
- The surface area of the sphere x2 + y2 + z2 = 9 lying inside the cylinder x2 + y2 = 3y is
- CUET (PG) - 2023
- Surface Area of Cube, Cuboid and Cylinder
- The Ombudsman in a newspaper organisation represents the point of view of the ___.
- CUET (PG) - 2023
- Journalism
- The orthogonal trajectories of the family of curves y = \(ax^3\) is
- The minimum distance of the point (3, 4, 12) from the sphere x2 + y2 + z2 = 1 is
- CUET (PG) - 2023
- Coordinate Geometry
View More Questions