Question:
Phenol on treatment with formaldehyde in dilute alkaline solution, gives:
Phenol on treatment with formaldehyde in dilute alkaline solution, gives:
Updated On: Jul 28, 2022
- bakelite
- terylene
- nylon
- none of these
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
By the reaction of phenol with formaldehyde, a thermosetting polymer, bakelite is obtained.
Was this answer helpful?
0
0
Top Questions on Alcohols, Phenols and Ethers
- JEE Main - 2024
- Chemistry
- Alcohols, Phenols and Ethers
- Which among the following has highest boiling point?
- JEE Main - 2024
- Chemistry
- Alcohols, Phenols and Ethers
- Given below are two statements:
Statement (I): p-nitrophenol is more acidic than m-nitrophenol and o-nitrophenol.
Statement (II): Ethanol will give immediate turbidity with Lucas reagent.
In the light of the above statements, choose the correct answer from the options given below:- JEE Main - 2024
- Chemistry
- Alcohols, Phenols and Ethers
- Highest enol content will be shown by:
- JEE Main - 2024
- Chemistry
- Alcohols, Phenols and Ethers
- Which of the following on reaction with NaOI will give yellow precipitates?
(A) Phenylethanone
(B) Sec-Butyl alcohol
(C) Phenylethanal
(D) Methyl n-propylketone
Choose the correct answer from the options given below:- CUET (UG) - 2024
- Chemistry
- Alcohols, Phenols and Ethers
View More Questions
Questions Asked in Rajasthan PMT exam
- 300 cal of heat is supplied to raise the temperature of 50 g of air from $ 20{}^\circ C $ to $ 30{}^\circ C $ without any change in its volume. Change in internal energy per gram of air is
- Rajasthan PMT - 2011
- internal energy
- The velocity of water flowing in a non-uniform tube is 20 cm/s at a point where the tube radius is 0.2 cm. The velocity at another point, where the radius is 0.1 cm, is
- Rajasthan PMT - 2011
- mechanical properties of fluid
- Block A of mass 4 kg and block B of mass 6 kg are resting on a horizontal surface as shown in the figure. There is no friction between the block B and the horizontal surface. The coefficient of friction between the blocks is 0.2. If the value of $ g=10\,m/{{s}^{2}}, $ the maximum horizontal force F that can be applied on block B without any relative motion between A and B is
- The excess pressure inside a soap bubble A is twice that in another soap bubble B. The ratio of volumes of A and B is
- Rajasthan PMT - 2011
- Surface tension
- The unit of surface tension is
- Rajasthan PMT - 2011
- Surface tension
View More Questions
Concepts Used:
Alcohols, Phenols, and Ethers
Alcohol is formed when a saturated carbon atom bonds to a hydroxyl (-OH) group. It is an organic compound that contains a hydroxyl functional group attached to a carbon atom.
Phenol is formed when the -OH group replaces the hydrogen atom in benzene. It is an organic compound in which a hydroxyl group directly attaches to an aromatic hydrocarbon.
Ether is formed when oxygen atom bonds to two alkyl or aryl groups. It is an organic compound that has an oxygen atom that is connected to two aryl and alkyl groups.
Read More: Alcohol, Phenol, and Ethers