>
questions
List of practice Questions
A Pelton wheel develops 5520 kW under a head of 225 m at an overall efficiency of 80% when revolving at a speed of 300 rpm. Then the unit speed is
TS PGECET - 2024
TS PGECET
Civil Engineering
Hydrology
In a ghat area, the average annual rainfall observed is 500 mm. Then the average annual runoff in millimetres as per the Inglis and DeSouza's formula is
TS PGECET - 2024
TS PGECET
Civil Engineering
Water Resources
Wind blowing over the water surface in the reservoir developed a wave of height 2 m. Then the wave force in kN/m on the upper portion of gravity dam is
TS PGECET - 2024
TS PGECET
Civil Engineering
Irrigation
If wheat requires about 75 mm of water after every 28 days, and the base period for wheat is 140 days, the value of delta for wheat is
TS PGECET - 2024
TS PGECET
Civil Engineering
Irrigation
From a sieve analysis test on a soil sample, the mean size of particles observed is 1 mm. The Lacey’s silt factor is
TS PGECET - 2024
TS PGECET
Civil Engineering
Irrigation
A pitot tube is used to measure
TS PGECET - 2024
TS PGECET
Civil Engineering
Fluid Mechanics
A square lamina (each side equal to 2m) is submerged vertically in water such that the upper edge of the lamina is at a depth of 0.5 m from the free surface. What will be the total water pressure (in kN) on the lamina? (take \( \gamma_w = 10 \, \text{kN/m}^3 \))
TS PGECET - 2024
TS PGECET
Civil Engineering
Fluid Mechanics
An ideal flow of a liquid obeys:
TS PGECET - 2024
TS PGECET
Civil Engineering
Fluid Mechanics
In which of the following cases, the hydraulic jump is not possible?
TS PGECET - 2024
TS PGECET
Civil Engineering
Fluid Mechanics
For critical flow conditions in rectangular channels, which of the following is the correct relationship between critical depth \( y_c \) and specific energy \( E \)?
TS PGECET - 2024
TS PGECET
Civil Engineering
Fluid Mechanics
Which factor does not contribute to the instability of slopes?
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
The bearing capacity of soil supporting a footing of size $ 3 \, \text{m} \times 3 \, \text{m} $ will not be affected by the presence of water table located at a depth below the base of footing of
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
The intensity of active earth pressure at a depth of 10 metres in dry cohesionless sand with an angle of internal friction of \( 30^\circ \) and with a weight of \( 1.8 \, \text{t/m}^3 \) is
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
If the actual value of the standard penetration number, SPT N measured in fine sand below the water table is 19, then the corrected value of SPT N for dilatancy is
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
What is the purpose of pile caps in deep foundation systems?
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
The active earth pressure of a soil is proportional to (where \( \phi \) is the angle of internal friction of soil)
TS PGECET - 2024
TS PGECET
Civil Engineering
Soil Mechanics
The water content at which soil just begins to crumble when rolled into threads of 3 mm in diameter is known
TS PGECET - 2024
TS PGECET
Civil Engineering
Soil Mechanics
The lateral earth pressure on a retaining wall is called passive earth pressure when
TS PGECET - 2024
TS PGECET
Civil Engineering
Soil Mechanics
Minimum size of the particles of silty soil is
TS PGECET - 2024
TS PGECET
Civil Engineering
Soil Mechanics
General shear failure is common in which of the following soils?
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
As per the BIS:1904 (1986), the maximum permissible settlement for raft foundations on sand is
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
In a plate load test on clay soil, the ratio of ultimate bearing capacity of footing to the ultimate bearing capacity of plate is
TS PGECET - 2024
TS PGECET
Civil Engineering
Foundation Engineering
For a steel built-up column subjected to an axial force of 1200 kN, the lacing system is to be designed for resisting transverse shear of
TS PGECET - 2024
TS PGECET
Civil Engineering
Soil Mechanics
In a liquid limit test, the moisture content at 10 blows was 70% and that at 100 blows was 20%. The flow index of soil is
TS PGECET - 2024
TS PGECET
Civil Engineering
Soil Mechanics
A soil which was compacted at 10% moisture content has bulk unit weight of \( 22 \, \text{kN/m}^3 \). Then its dry unit weight is
TS PGECET - 2024
TS PGECET
Civil Engineering
Soil Mechanics
Prev
1
...
2840
2841
2842
2843
2844
...
8524
Next