List of practice Questions

The creep in belt drive is due to the:
Spur gears have:
A flow in which each liquid particle has a definite path and their paths do not cross each other, is called:
Which of the following metals shows a clear yield point?
Cold working process can be applied on the components having diameter up to:
Thermal stress occurs when:
In a vapour compression refrigeration cycle, the refrigerant absorbs heat in the following.
Group technology brings together and organizes:
Forging is typically done:
With rise in gas temperature, dynamic viscosity of most of the gases:
The instantaneous centre of rotation of a rigid thin disc rolling on a plane rigid surface is located at:
The gears employed for connecting two non-intersecting and non-parallel, i.e., non-coplanar shafts are:
Which of the machining processes uses the principle of Faraday’s law for material removal?
A master gauge is an:
Gating system in casting controls:
For the two shafts connected in parallel, find which statement is true?
Amount of external energy required to deform an elastic body is called:
Balancing of a rigid rotor can be achieved by appropriately balancing masses in:
Forecasting in PPC helps in:
Heat transfer takes place according to:
The locus of elevations that water will rise in a series of pitot tubes is called:
Which material is commonly used for pattern making?
Strength of a material is its ability to resist:
As the distance from the leading edge increases, the thermal boundary layer thickness:
Provision of fins on a given heat transfer surface will be more, if there are: