Question:
Instruments required to synchronize an alternator to the grid are:
Instruments required to synchronize an alternator to the grid are:
Show Hint
To synchronize an alternator to the grid:
- The voltage and frequency must match, and the phase angle must be aligned using a synchroscope.
Updated On: Feb 14, 2025
- Wattmeter
- Voltmeter
- Synchroscope
- Stroboscope
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
Step 1: Synchronizing an alternator to the grid requires monitoring the voltage, frequency, and phase angle to match the alternator’s output to the grid’s conditions.
Step 2: The essential instruments used in this process are: - Voltmeter to measure the voltage magnitude.
- Synchroscope to measure the phase difference between the alternator and grid voltage.
Thus, the correct instruments are the Voltmeter and Synchroscope.
Step 2: The essential instruments used in this process are: - Voltmeter to measure the voltage magnitude.
- Synchroscope to measure the phase difference between the alternator and grid voltage.
Thus, the correct instruments are the Voltmeter and Synchroscope.
Was this answer helpful?
0
0
Top Questions on Power
- The single line diagram of a lossless system is shown in the figure. The system is operating in steady-state at a stable equilibrium point with the power output of the generator being \( P_{max} \sin \delta \), where \( \delta \) is the load angle and the mechanical power input is \( 0.5 P_{max} \). A fault occurs on line 2 such that the power output of the generator is less than \( 0.5 P_{max} \) during the fault. After the fault is cleared by opening line 2, the power output of the generator is \( \frac{P_{max}}{\sqrt{2}} \sin \delta \). If the critical fault clearing angle is \( \pi/2 \) radians, the accelerating area on the power angle curve is \_\_\_ times \( P_{max} \) (rounded off to 2 decimal places).
\includegraphics[width=0.5\linewidth]{56.png} - A 3-phase, 11 kV, 10 MVA synchronous generator is connected to an inductive load of power factor \( \frac{\sqrt{3}}{2} \) via a lossless line with a per-phase inductive reactance of \( 5\Omega \). The per-phase synchronous reactance of the generator is \( 30\Omega \). If the generator is producing the rated current at the rated voltage, then the power factor at the terminal of the generator is:
- For the three-bus lossless power network shown in the figure, the voltage magnitudes at all the buses are equal to 1 per unit (pu), and the differences of the voltage phase angles are very small. The line reactances are marked in the figure, where $\alpha$, $\beta$, $\gamma$, and $x$ are strictly positive. The bus injections $P_1$ and $P_2$ are in pu. If $P_1 = mP_2$, where $m>0$ and the real power flow from bus 1 to bus 2 is 0 pu, then which one of the following options is correct?
\includegraphics[width=0.5\linewidth]{41.png} - A forced commutated thyristorized step-down chopper is shown. Neglect the ON-state drop across power devices. Assume that the capacitor is initially charged to 50 V with the polarity shown in the figure. The load current \(I_l\) can be assumed to be constant at 10 A. Initially, \(Th_M\) is ON and \(ThA\) is OFFThe turn-off time available to \( T_{H4} \) in microseconds, when \( T_{H4} \) is triggered, is \_\_\_\_\_ (rounded off to the nearest integer).
\includegraphics[width=0.5\linewidth]{35.png} - If the following switching devices have similar power ratings, which one of them is the fastest?
View More Questions
Questions Asked in GATE EE exam
The op-amps in the following circuit are ideal. The voltage gain of the circuit is ……….. . (Round off to the nearest integer)
- GATE EE - 2025
- Digital voltmeters and multi-meters
The maximum percentage error in the equivalent resistance of two parallel connected resistors of 100 ohm and 900 ohm, with each having a maximum 5% error, is:
- GATE EE - 2025
- Bridges and Potentiometers
A controller \( (1 + K_{DS}) \) is to be designed for the plant \[ G(s) = \frac{1000 \sqrt{2}}{s(s + 10)^2} \] The value of \( K_D \) that yields a phase margin of 45 degrees at the gain cross-over frequency of 10 rad/sec is ……… (round off to 1 decimal place).
- GATE EE - 2025
- Active Filters
Consider the state-space model:
\[ \dot{x}(t) = A x(t) + B u(t) \] \[ y(t) = C x(t) \] \[ A = \begin{bmatrix} 0 & 1 \\ -2 & -3 \end{bmatrix}, \quad B = \begin{bmatrix} 0 \\ 1 \end{bmatrix}, \quad C = \begin{bmatrix} 1 & 0 \end{bmatrix} \]The sum of the magnitudes of the poles is:
- GATE EE - 2025
- Active Filters
- The open-loop transfer function of the system shown in the figure is: \[ G(s) = \frac{K s (s + 2)}{(s + 5)(s + 7)} \] For \( K \geq 0 \), which of the following real-axis points is on the root locus?
- GATE EE - 2025
- Digital voltmeters and multi-meters
View More Questions