In the meter bridge shown below, the null point is at 40 cm from A. If R is shunted by 22, find the distance of new balance point from A
- 22.7 cm
- 60 cm
- 62.5 cm
- 60.5 cm
The Correct Option is C
Solution and Explanation
Top Questions on Resistance
- The effective resistance between points A and B in the given circuit is:
A wire of resistance $ R $ is bent into a triangular pyramid as shown in the figure, with each segment having the same length. The resistance between points $ A $ and $ B $ is $ \frac{R}{n} $. The value of $ n $ is:
- JEE Main - 2025
- Physics
- Resistance
- A wire of resistance \( X \, \Omega \) is gradually stretched till its length becomes twice its original length. If its new resistance becomes 40 \( \Omega \), find the value of \( X \).
- A wire of resistance \( R \), connected to an ideal battery, consumes a power \( P \). If the wire is gradually stretched to double its initial length, and connected across the same battery, the power consumed will be:
- Find the effective resistance of the network of resistors between points A and F as shown in the figure.
Questions Asked in JEE Main exam
Consider an A.P. $a_1,a_2,\ldots,a_n$; $a_1>0$. If $a_2-a_1=-\dfrac{3}{4}$, $a_n=\dfrac{1}{4}a_1$, and \[ \sum_{i=1}^{n} a_i=\frac{525}{2}, \] then $\sum_{i=1}^{17} a_i$ is equal to
- JEE Main - 2026
- Arithmetic Progression
- A thin convex lens of focal length \( 5 \) cm and a thin concave lens of focal length \( 4 \) cm are combined together (without any gap), and this combination has magnification \( m_1 \) when an object is placed \( 10 \) cm before the convex lens.
Keeping the positions of the convex lens and the object undisturbed, a gap of \( 1 \) cm is introduced between the lenses by moving the concave lens away. This leads to a change in magnification of the total lens system to \( m_2 \).
The value of \( \dfrac{m_1}{m_2} \) is
- Two blocks with masses 100 g and 200 g are attached to the ends of springs A and B as shown in figure. The energy stored in A is E. The energy stored in B, when spring constants \(k_A, k_B\) of A and B, respectively satisfy the relation \(4k_A = 3k_B\), is :
- JEE Main - 2026
- Alternating current
- Correct statements regarding Arrhenius equation among the following are:
Factor \(e^{-E_a/RT}\) corresponds to fraction of molecules having kinetic energy less than \(E_a\).
At a given temperature, lower the \(E_a\), faster is the reaction.
Increase in temperature by about \(10^\circ\text{C}\) doubles the rate of reaction.
Plot of \(\log k\) vs \(\dfrac{1}{T}\) gives a straight line with slope \(= -\dfrac{E_a}{R}\).
Choose the correct answer from the options given below:- JEE Main - 2026
- Chemical Kinetics
- If the image of the point \( P(1, 2, a) \) in the line \[ \frac{x - 6}{3} = \frac{y - 7}{2} = \frac{7 - z}{2} \] is \( Q(5, b, c) \), then \( a^2 + b^2 + c^2 \) is equal to
- JEE Main - 2026
- Distance of a Point From a Line
Concepts Used:
Resistance
Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.
R=V/I
In this case,
v = Voltage across its ends
I = Current flowing through it
All materials resist current flow to some degree. They fall into one of two broad categories:
- Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
- Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.
Resistance measurements are normally taken to indicate the condition of a component or a circuit.
- The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
- The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.