In the given circuit, the diodes are ideal. The current \( I \) through the diode \( D_1 \) in milliamperes is (rounded off to two decimal places).
In the given circuit, the diodes are ideal. The current \( I \) through the diode \( D_1 \) in milliamperes is (rounded off to two decimal places).
Show Hint
Correct Answer: 1.64 - 1.7
Solution and Explanation
Step 1: Analyze the circuit. Using ideal diode assumptions, determine which diodes are conducting. Solve for \( I \) using Kirchhoff's Voltage Law (KVL) and Ohm's Law.
Step 2: Calculate the current \( I \). After analyzing the circuit: \[ I = 1.64 \, \text{to} \, 1.70 \, \text{mA}. \]
Top Questions on Current
A single-phase half-controlled bridge converter supplies an inductive load with ripple-free load current. The triggering angle of the converter is \( 60^\circ \). The ratio of the rms value of the fundamental component of the input current to the rms value of the total input current of the bridge is (rounded off to 3 decimal places).
In the DC–DC converter shown in the figure, the current through the inductor is continuous. The switching frequency is \(500\,\text{Hz}\).
The output voltage \(V_o\) across the load is assumed to be constant and ripple-free.
The peak value of the inductor current (in amperes) is __________ (rounded off to the nearest integer).
A single-phase full-controlled thyristor converter bridge is used for regenerative braking of a separately excited DC motor with the following specifications:
- Rated armature voltage = 210 V
- Rated armature current = 10 A
- Rated speed = 1200 rpm
- Armature resistance = 1 Ω
- Input to the converter bridge = 240 V at 50 Hz
Assume that the motor is running at 600 rpm and the armature terminals are suitably reversed for regenerative braking.
If the armature current of the motor is to be maintained at the rated value, the triggering angle of the converter bridge (in degrees) should be ____________ (rounded off to two decimal places).
Motor and converter parameters:
Parameter Value Rated armature voltage 210 V Rated armature current 10 A Rated speed 1200 rpm Armature resistance 1 Ω Input to converter bridge 240 V at 50 Hz The armature of the DC motor is fed from the full-controlled bridge, and the field current is maintained constant.
A difference amplifier is shown in the figure. Assume the op-amp to be ideal. The CMRR (in dB) of the difference amplifier is (rounded off to 2 decimal places).
Consider the stable closed-loop system shown in the figure. The magnitude and phase values of the frequency response of \( G(s) \) are given in the table below. The value of the gain \( K_I \; (>0) \) required for a 50° phase margin is __________ (rounded off to two decimal places).
Frequency response data of \( G(s) \):
\(\omega\) (rad/s) Magnitude (dB) Phase (degrees) 0.5 -7 -40 1.0 -10 -80 2.0 -18 -130 10.0 -40 -200 System diagram:
Questions Asked in GATE EE exam
A continuous time periodic signal \( x(t) \) is given by: \[ x(t) = 1 + 2\cos(2\pi t) + 2\cos(4\pi t) + 2\cos(6\pi t) \] If \( T \) is the period of \( x(t) \), then evaluate: \[ \frac{1}{T} \int_0^T |x(t)|^2 \, dt \quad {(round off to the nearest integer).} \]
- GATE EE - 2025
- Digital Signal Processing
The maximum percentage error in the equivalent resistance of two parallel connected resistors of 100 \( \Omega \) and 900 \( \Omega \), with each having a maximum 5% error, is: \[ {(round off to nearest integer value).} \]
- GATE EE - 2025
- Electrical Energy, Power
Consider a distribution feeder, with \( R/X \) ratio of 5. At the receiving end, a 350 kVA load is connected. The maximum voltage drop will occur from the sending end to the receiving end, when the power factor of the load is: \[ {(round off to three decimal places).} \]
In the circuit with ideal devices, the power MOSFET is operated with a duty cycle of 0.4 in a switching cycle with \( I = 10 \, {A} \) and \( V = 15 \, {V} \). The power delivered by the current source, in W, is: \[ {(round off to the nearest integer).} \]
- GATE EE - 2025
- Electrical Circuits
The induced emf in a 3.3 kV, 4-pole, 3-phase star-connected synchronous motor is considered to be equal and in phase with the terminal voltage under no-load condition. On application of a mechanical load, the induced emf phasor is deflected by an angle of \( 2^\circ \) mechanical with respect to the terminal voltage phasor. If the synchronous reactance is \( 2 \, \Omega \), and stator resistance is negligible, then the motor armature current magnitude, in amperes, during loaded condition is closest to: \[ {(round off to two decimal places).} \]
- GATE EE - 2025
- Electrical Energy, Power