In a series LCR circuit, the inductance, capacitance and resistance are L = 100 mH, C = 100 μF and R = 10 Ω respectively. They are connected to an AC source of voltage 220 V and frequency of 50 Hz. The approximate value of current in the circuit will be ______ A.
In a series LCR circuit, the inductance, capacitance and resistance are L = 100 mH, C = 100 μF and R = 10 Ω respectively. They are connected to an AC source of voltage 220 V and frequency of 50 Hz. The approximate value of current in the circuit will be ______ A.
Correct Answer: 22
Solution and Explanation
\(Z=\sqrt{R^2+(X_L-X_C)^2}\)
\(=\sqrt{10^2+[10\pi-\frac{100}{\pi}]^2} Ω\)
≃10 Ω
⇒ Current
\(=\frac{220}{10}A=22\,A\)
Top Questions on Resistance
- The effective resistance between points A and B in the given circuit is:
A wire of resistance $ R $ is bent into a triangular pyramid as shown in the figure, with each segment having the same length. The resistance between points $ A $ and $ B $ is $ \frac{R}{n} $. The value of $ n $ is:
- JEE Main - 2025
- Physics
- Resistance
- A wire of resistance \( X \, \Omega \) is gradually stretched till its length becomes twice its original length. If its new resistance becomes 40 \( \Omega \), find the value of \( X \).
- A wire of resistance \( R \), connected to an ideal battery, consumes a power \( P \). If the wire is gradually stretched to double its initial length, and connected across the same battery, the power consumed will be:
- Find the effective resistance of the network of resistors between points A and F as shown in the figure.
Questions Asked in JEE Main exam
In the given figure, the blocks $A$, $B$ and $C$ weigh $4\,\text{kg}$, $6\,\text{kg}$ and $8\,\text{kg}$ respectively. The coefficient of sliding friction between any two surfaces is $0.5$. The force $\vec{F}$ required to slide the block $C$ with constant speed is ___ N.
(Given: $g = 10\,\text{m s}^{-2}$)
- JEE Main - 2026
- Rotational Mechanics
- If the coefficient of \( x \) in the expansion of \[ (ax^2 + bx + c)(1 - 2x)^{26} \] is \(-56\) and the coefficients of \( x^2 \) and \( x^3 \) are both zero, then \( a + b + c \) is equal to
- JEE Main - 2026
- Binomial theorem
The equivalent resistance between the points \(A\) and \(B\) in the given circuit is \[ \frac{x}{5}\,\Omega. \] Find the value of \(x\).
- JEE Main - 2026
- Current electricity
Method used for separation of mixture of products (B and C) obtained in the following reaction is:
- JEE Main - 2026
- p -Block Elements
- Consider light travelling from a medium A to medium B separated by a plane interface. If the light undergoes total internal reflection during its travel from medium A to B and the speed of light in media A and B are \(2.4 \times 10^8\) m/s and \(2.7 \times 10^8\) m/s, respectively, then the value of critical angle is :
- JEE Main - 2026
- Newtons Laws of Motion
Concepts Used:
Resistance
Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.
R=V/I
In this case,
v = Voltage across its ends
I = Current flowing through it
All materials resist current flow to some degree. They fall into one of two broad categories:
- Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
- Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.
Resistance measurements are normally taken to indicate the condition of a component or a circuit.
- The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
- The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.