>
Exams
>
Instrumentation Engineering
>
Control Systems
>
if the transfer function of a system is g s frac a
Question:
If the transfer function of a system is \( G(s) = \frac{A}{s^2 + \omega^2} \), then the steady state gain of the system to a unit step input is:
Show Hint
Use Final Value Theorem: \( \lim_{t \to \infty} y(t) = \lim_{s \to 0} sY(s) \).
TS PGECET - 2024
TS PGECET
Updated On:
May 26, 2025
\( \frac{A}{\omega^2} \)
zero
infinity
Not possible to be determined
Hide Solution
Verified By Collegedunia
The Correct Option is
A
Solution and Explanation
The steady state value of the system’s output to a unit step input can be found using the Final Value Theorem: \[ \lim_{t \to \infty} y(t) = \lim_{s \to 0} s \cdot G(s) \cdot \frac{1}{s} = G(0) = \frac{A}{\omega^2} \]
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Control Systems
The Block diagram for a control system is shown below:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
Bode diagram is a plot of (AR is amplitude ratio; $\omega$ is frequency factor and $\phi$ is phase angle):
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
The transfer function of a PID controller is:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
The characteristic equation for the system is
\[ s^3 + 9s^2 + 26s + 12(2 + K_c) = 0 \]
Using Routh test, the value of Kc that will keep the system stable is:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
The Bode diagram stability criterion is applicable when:
CUET (PG) - 2025
Chemical, Thermal and Polymer Engineering
Control Systems
View Solution
View More Questions
Questions Asked in TS PGECET exam
In which year was the Earth Summit (Rio Conference) held?
TS PGECET - 2025
Environmental pollution
View Solution
A bag contains 3 red and 2 blue balls. Two balls are drawn without replacement. What is the probability that both are red?
TS PGECET - 2025
Probability
View Solution
Which of the following techniques is primarily used for the synthesis of carbon nanotubes?
TS PGECET - 2025
Strength of Materials
View Solution
The top-down approach in nanofabrication refers to:
TS PGECET - 2025
Metrology and Inspection
View Solution
The term "carrying capacity" refers to:
TS PGECET - 2025
Sustainable Development
View Solution
View More Questions