Question:
Formalin is:
Formalin is:
Updated On: Jun 23, 2023
- $ HCHO $
- $CH_{3}CHO$
- $ HCOOH $
- $CH_{3}COOH $
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
Formalin is a solution of formaldehyde.
Was this answer helpful?
0
0
Top Questions on Solutions
- Which of the following compound can give positive iodoform test when treated with aqueous KOH solution followed by potassium hypoiodite.
- A molecule X associates in a given solvent as per the following equation:
X ⇌ (X)n
For a given concentration of X, the van’t Hoff factor was found to be 0.80 and the
fraction of associated molecules was 0.3. The correct value of ‘n’ is: - Arrange the following compounds in increasing order of their solubilities in chloroform:
NaCl, CH3OH, cyclohexane, CH3CN - The amount of glucose required to prepare 250 mL of \( \frac{M}{20} \) aqueous solution is:
(Molar mass of glucose: 180 g mol-1) - Mass of ethylene glycol (antifreeze) to be added to 18.6 kg of water to protect the freezing point at $-24^\circ C$ is ____ kg (Molar mass in g mol$^{-1}$ for ethylene glycol = 62, $K_f$ of water = 1.86 K kg mol$^{-1}$).
View More Questions
Questions Asked in Rajasthan PMT exam
- 300 cal of heat is supplied to raise the temperature of 50 g of air from $ 20{}^\circ C $ to $ 30{}^\circ C $ without any change in its volume. Change in internal energy per gram of air is
- Rajasthan PMT - 2011
- internal energy
- The velocity of water flowing in a non-uniform tube is 20 cm/s at a point where the tube radius is 0.2 cm. The velocity at another point, where the radius is 0.1 cm, is
- Rajasthan PMT - 2011
- mechanical properties of fluid
- Block A of mass 4 kg and block B of mass 6 kg are resting on a horizontal surface as shown in the figure. There is no friction between the block B and the horizontal surface. The coefficient of friction between the blocks is 0.2. If the value of $ g=10\,m/{{s}^{2}}, $ the maximum horizontal force F that can be applied on block B without any relative motion between A and B is
- The excess pressure inside a soap bubble A is twice that in another soap bubble B. The ratio of volumes of A and B is
- Rajasthan PMT - 2011
- Surface tension
- The unit of surface tension is
- Rajasthan PMT - 2011
- Surface tension
View More Questions
Concepts Used:
Solutions
A solution is a homogeneous mixture of two or more components in which the particle size is smaller than 1 nm.
For example, salt and sugar is a good illustration of a solution. A solution can be categorized into several components.
Types of Solutions:
The solutions can be classified into three types:
- Solid Solutions - In these solutions, the solvent is in a Solid-state.
- Liquid Solutions- In these solutions, the solvent is in a Liquid state.
- Gaseous Solutions - In these solutions, the solvent is in a Gaseous state.
On the basis of the amount of solute dissolved in a solvent, solutions are divided into the following types:
- Unsaturated Solution- A solution in which more solute can be dissolved without raising the temperature of the solution is known as an unsaturated solution.
- Saturated Solution- A solution in which no solute can be dissolved after reaching a certain amount of temperature is known as an unsaturated saturated solution.
- Supersaturated Solution- A solution that contains more solute than the maximum amount at a certain temperature is known as a supersaturated solution.