Question:
For calorically perfect gas, specific heats \(C_p\) and \(C_v\) are
For calorically perfect gas, specific heats \(C_p\) and \(C_v\) are
Show Hint
This simplification allows easier analysis of many basic gas dynamics problems, such as those involving isentropic flows.
Updated On: July 22, 2025
- constant
- function of temperature
- function of pressure
- function of density
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
Step 1: Define Calorically Perfect Gas.
In a calorically perfect gas, the specific heats (\(C_p\) and \(C_v\)) are constant and do not change with temperature, pressure, or density.
In a calorically perfect gas, the specific heats (\(C_p\) and \(C_v\)) are constant and do not change with temperature, pressure, or density.
Was this answer helpful?
0
0
Top Questions on Heat Transfer
- From a metallic wall at 100$^\circ$C, a metallic rod protrudes to the ambient air. The temperature at the tip will be minimum when the rod is made of:
- AP PGECET - 2025
- Mechanical Engineering
- Heat Transfer
- As the distance from the leading edge increases, the thermal boundary layer thickness:
- AP PGECET - 2025
- Mechanical Engineering
- Heat Transfer
- Provision of fins on a given heat transfer surface will be more, if there are:
- AP PGECET - 2025
- Mechanical Engineering
- Heat Transfer
- Highest thermal conductivity is of
- AP PGECET - 2025
- Mechanical Engineering
- Heat Transfer
- Nusselt number is the ratio of:
- AP PGECET - 2025
- Mechanical Engineering
- Heat Transfer
View More Questions
Questions Asked in TANCET exam
- The faces in a tetragon are
- TANCET - 2024
- Crystallography
- What letter replaces the question mark?
- What is in this sequence? Y, V, S, P, ___
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
View More Questions
TANCET Notification
GMC Azamgarh Admission 2025: Dates, Courses, Fees, Eligibility, SelectJuly 22, 2025GMC Azamgarh Admission 2025