The following circuit contains diodes with forward bias having resistance \(25Ω\), and reverse bias having infinite resistance. The ratio of \(\frac{I_{1}}{I_{2}}\) is equal to
The following circuit contains diodes with forward bias having resistance \(25Ω\), and reverse bias having infinite resistance. The ratio of \(\frac{I_{1}}{I_{2}}\) is equal to
- 1
- 2
- 3
- 4
The Correct Option is B
Solution and Explanation
The correct option is (B): 2
I2=I4
I3=0
and I2+I4+I3=I1
\(\Rightarrow I_2=\frac{I_1}{2}\)
Top Questions on Electric Field
- An electron is released in the field generated by a non-conductivity sheet of uniform surface charge density $ \sigma $. The rate of change of de-Broglie wavelength associated with the electron varies inversely as the $ n $th power of the distance travelled. Find the value of $ n $.
- JEE Main - 2025
- Physics
- Electric Field
- A potential at a point A is 3 V and that at another point B is 5 V. What is the work done in carrying a charge of 5 mC from B to A?
- KCET - 2025
- Physics
- Electric Field
Two large plane parallel conducting plates are kept 10 cm apart as shown in figure. The potential difference between them is $ V $. The potential difference between the points A and B (shown in the figure) is:
- JEE Main - 2025
- Physics
- Electric Field
- Work done to move a unit charge from one point to the other in an electric circuit is called
- AP POLYCET - 2025
- Physics
- Electric Field
- Electric field lines around a positive charge are directed:
- KEAM - 2025
- Physics
- Electric Field
Questions Asked in JEE Main exam
- A conducting bar moves on two conducting rails as shown in the figure. A constant magnetic field \( B \) exists into the page. The bar starts to move from the vertex at time \( t = 0 \) with a constant velocity. If the induced EMF is \( E \propto t^n \), then the value of \( n \) is ________________________.
- JEE Main - 2025
- Electromagnetic induction
- A radioactive nucleus \( n_2 \) has 3 times the decay constant as compared to the decay constant of another radioactive nucleus \( n_1 \). If the initial number of both nuclei are the same, what is the ratio of the number of nuclei of \( n_2 \) to the number of nuclei of \( n_1 \), after one half-life of \( n_1 \)?
- JEE Main - 2025
- Radioactive Decay
- Assume a living cell with 0.9%(\(w/w\)) of glucose solution (aqueous). This cell is immersed in another solution having equal mole fraction of glucose and water. (Consider the data up to first decimal place only) The cell will:
- JEE Main - 2025
- osmosis
- A force of 49 N acts tangentially at the highest point of a sphere (solid of mass 20 kg) kept on a rough horizontal plane. If the sphere rolls without slipping, then the acceleration of the center of the sphere is:
- JEE Main - 2025
- Quantum Mechanics
- The distance of the point \( (7, 10, 11) \) from the line \( \frac{x-9}{2} = \frac{y-13}{3} = \frac{z-17}{6} \) along the line is:
- JEE Main - 2025
- Geometry
Concepts Used:
Resistance
Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.
R=V/I
In this case,
v = Voltage across its ends
I = Current flowing through it
All materials resist current flow to some degree. They fall into one of two broad categories:
- Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
- Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.
Resistance measurements are normally taken to indicate the condition of a component or a circuit.
- The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
- The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.