>
Exams
>
Computer Awareness
>
Computer Organization and Architecture
>
collection of wires that carry address data signal
Question:
Collection of wires that carry address data signals from control unit to other parts of computer system is called as
Show Hint
In computer architecture, the address bus is responsible for transferring memory addresses to the components of the system.
TANCET - 2024
TANCET
Updated On:
July 22, 2025
Data bus
Control bus
Address bus
Communication wires
Hide Solution
Verified By Collegedunia
The Correct Option is
C
Solution and Explanation
Step 1:
The address bus is the collection of wires that carry address data signals from the control unit to other parts of the computer system.
Step 2:
The data bus carries the actual data, while the control bus is used for control signals.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Computer Organization and Architecture
What is the unit of transfer data from main memory to cache memory?
TS PGECET - 2024
Computer Science & Information Technology
Computer Organization and Architecture
View Solution
Which type of I/O does NOT use interrupts?
TS PGECET - 2024
Computer Science & Information Technology
Computer Organization and Architecture
View Solution
Which RAID level describes block interleaved distributed parity?
TS PGECET - 2024
Computer Science & Information Technology
Computer Organization and Architecture
View Solution
In disk organization, the time taken by the head to reach the beginning of sector is
TS PGECET - 2024
Computer Science & Information Technology
Computer Organization and Architecture
View Solution
Which set of the following instructions is used for program control?
TS PGECET - 2024
Computer Science & Information Technology
Computer Organization and Architecture
View Solution
View More Questions
Questions Asked in TANCET exam
The faces in a tetragon are
TANCET - 2024
Crystallography
View Solution
What letter replaces the question mark?
TANCET - 2024
Series
View Solution
What is in this sequence? Y, V, S, P, ___
TANCET - 2024
Series
View Solution
An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
TANCET - 2024
Machine Design
View Solution
A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
TANCET - 2024
Time, Speed and Distance
View Solution
View More Questions
TANCET Notification
GMC Azamgarh Admission 2025: Dates, Courses, Fees, Eligibility, Select
July 22, 2025
GMC Azamgarh Admission 2025
Read More