Question:
Change Point (CP) in levelling refers to a location where
Change Point (CP) in levelling refers to a location where
Updated On: Jul 12, 2024
- only backsight reading is taken
- both backsight and foresight readings are taken
- survey work ends
- staff reading is taken on a benchmark
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
The correct answer is (B) : both backsight and foresight readings are taken
Was this answer helpful?
0
0
Top Questions on Principles of surveying
- A surveyor observes a zenith angle of 93° 00' 00" during a theodolite survey. The corresponding vertical angle is
- GATE CE - 2024
- Geomatics Engineering
- Principles of surveying
- What is the CORRECT match between the survey instruments/parts of instruments shown in the table and the operations carried out with them ?
Instruments/Parts of instruments Operations P Bubble tube i Tacheometry Q Plumb bob ii Minor movements R Tangent screw iii Centering S Stadia cross-wire iv Levelling - GATE CE - 2024
- Geomatics Engineering
- Principles of surveying
- To finalize the direction of a survey, four surveyors set up a theodolite at a station P and performed all the temporary adjustments. From the station P, each of the surveyors observed the bearing to a tower located at station Q with the same instrument without shifting it. The bearings observed by the surveyors are 30° 30' 00", 30° 29′ 40′′, 30° 30′ 20′′ and 30° 31′ 20′′. Assuming that each measurement is taken with equal precision, the most probable value of the bearing is
- GATE CE - 2024
- Geomatics Engineering
- Principles of surveying
- For a reconnaissance survey, it is necessary to obtain vertical aerial photographs of a terrain at an average scale of 1: 13000 using a camera. If the permissible flying height is assumed as 3000 m above a datum and the average terrain elevation is 1050 m above the datum, the required focal length (in mm) of the camera is
- GATE CE - 2024
- Geomatics Engineering
- Principles of surveying
- Which of the following statistical classification algorithms is/are represented by the figure given below?
- GATE CE - 2024
- Geomatics Engineering
- Principles of surveying
View More Questions
Questions Asked in GATE CE exam
- Find the odd one out in the set: {19, 37, 21, 17, 23, 29, 31, 11}
- GATE CE - 2024
- Odd one Out
- The initial cost of an equipment is Rs. 1,00,000. Its salvage value at the end of accounting life of 5 years is Rs. 10,000. The difference in depreciation (in Rs.) computed using 'double-declining balance method' and 'straight line method' of depreciation in Year-2 is ____ (in positive integer).
- GATE CE - 2024
- Construction Management
- A 2m × 2m tank of 3 m height has inflow, outflow and stirring mechanisms. Initially, the tank was half-filled with fresh water. At t = 0, an inflow of a salt solution of concentration 5 g/m3 at the rate of 2 litre/s and an outflow of the well stirred mixture at the rate of 1 litre/s are initiated. This process can be modelled using the following differential equation:
\(\frac {dm}{dt}+\frac {m}{6000+t}=0.01\)
where m is the mass (grams) of the salt at time t (seconds). The mass of the salt (in grams) in the tank at 75% of its capacity is _____ (rounded off to 2 decimal places).- GATE CE - 2024
- Properties of Fluids
- An inverted T-shaped concrete beam (B1) in the figure, with centroidal axis X - X, is subjected to an effective prestressing force of 1000 kN acting at the bottom kern point of the beam cross-section. Also consider an identical concrete beam (B2) with the same grade of concrete but without any prestressing force.
- GATE CE - 2024
- Concrete
- A 5m × 5m closed tank of 10 m height contains water and oil, and is connected to an overhead water reservoir as shown in the figure. Use \(γ_w=10\ kN/m^3\) and Specific gravity of oil = 0.8
- GATE CE - 2024
- Fluid Mechanics
View More Questions