>
Exams
>
Printing Technology
>
Post Press
>
buffer storage in mailroom systems is used for
Question:
Buffer storage in mailroom systems is used for
Show Hint
Buffer storage improves efficiency by managing the flow of printed materials.
TANCET - 2024
TANCET
Updated On:
Feb 27, 2025
Storing the unprinted sheets
Storing the printed sheets
Storing the materials used in printing
Storing the rejected newspapers
Hide Solution
Verified By Collegedunia
The Correct Option is
B
Solution and Explanation
Buffer storage in mailroom systems is used to temporarily hold printed sheets before further processing. This helps regulate workflow and prevents bottlenecks in sorting and distribution, improving overall operational efficiency.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Post Press
The placing of a section within another section is known as
TANCET - 2024
Printing Technology
Post Press
View Solution
Which of the following improves the book structure by giving it a convex spine and a concave fore edge?
TANCET - 2024
Printing Technology
Post Press
View Solution
A series of small holes very close to each other is made so that a position of the sheet of paper may be readily torn away and this operation is called
TANCET - 2024
Printing Technology
Post Press
View Solution
Which of the following is the type of machine used to fold thin papers?
TANCET - 2024
Printing Technology
Post Press
View Solution
Which of the following is the coating technique in which the varnish is applied to only selected portions?
TANCET - 2024
Printing Technology
Post Press
View Solution
View More Questions
Questions Asked in TANCET exam
What is in this sequence? Y, V, S, P, ___
TANCET - 2024
Series
View Solution
The faces in a tetragon are
TANCET - 2024
Crystallography
View Solution
What letter replaces the question mark?
TANCET - 2024
Series
View Solution
An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
TANCET - 2024
Machine Design
View Solution
A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
TANCET - 2024
Time, Speed and Distance
View Solution
View More Questions