Question:
A stream of a liquid of density \(ρ\) flowing horizontally with speed \(v\) rushes out of a tube of radius \(r\) and hits a vertical wall nearly normally. Assuming that the liquid does not rebound from the wall, the force exerted on the wall by the impact of the liquid is given by
A stream of a liquid of density \(ρ\) flowing horizontally with speed \(v\) rushes out of a tube of radius \(r\) and hits a vertical wall nearly normally. Assuming that the liquid does not rebound from the wall, the force exerted on the wall by the impact of the liquid is given by
Updated On: Jun 21, 2024
- \(\pi rρv\)
- \(\pi rρv^2\)
- \(\pi r^2ρv\)
- \(\pi r^2ρv^2\)
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
The correct option is (D): \(\pi r^2ρv^2\).
Was this answer helpful?
0
0
Top Questions on Fluid Mechanics
- For the Bernoulli's equation to be applicable in a fluid flow situation, which of the following conditions is/are to be satisfied:
- GATE CE - 2025
- Physics
- Fluid Mechanics
- For a flowing fluid, a dimensionless combination of velocity (V), length scale (l), and acceleration due to gravity (g) would be
- GATE CE - 2025
- Physics
- Fluid Mechanics
The shaft of a 6 m wide gate in the figure will fail at a moment of 3924 kN.m about the hinge P. The maximum value of water depth \( h \) (in m) that the gate can hold is ......... (round off to the nearest integer).
- GATE CE - 2025
- Civil Engineering
- Fluid Mechanics
- The drag force, \( F_D \), on a sphere due to a fluid flowing past the sphere is a function of viscosity, \( \mu \), the mass density, \( \rho \), the velocity of flow, \( V \), and the diameter of the sphere, \( D \). Pick the relevant (one or more) non-dimensional parameter(s) pertaining to the above process from the following list.
- GATE CE - 2025
- Civil Engineering
- Fluid Mechanics
Consider steady flow of water in the series pipe system shown below, with specified discharge. The diameters of Pipes A and B are 2 m and 1 m, respectively. The lengths of pipes A and B are 100 m and 200 m, respectively. Assume the Darcy-Weisbach friction coefficient, \( f \), as 0.01 for both the pipes.
The ratio of head loss in Pipe-B to the head loss in Pipe-A is ___________ (round off to the nearest integer).
- GATE CE - 2025
- Civil Engineering
- Fluid Mechanics
View More Questions
Questions Asked in JIPMER MBBS exam
- Speed of particles at 3rd and 8th seconds are 20 m/s are zero respectively. Then average acceleration between 3rd and 8th second will be -
- JIPMER MBBS - 2019
- Kinematics
- What is the value of γ for a monoatomic gas (ideal gas):
- JIPMER MBBS - 2019
- Ideal gas equation
- Write the IUPAC name of the following
- JIPMER MBBS - 2019
- Nomenclature Of Organic Compounds
- Find the current drawn from the battery just after the switch is closed
- JIPMER MBBS - 2019
- An Electric Circuit
- If same charge q is placed inside a sphere and cube having radius 1m and side 2m respectively. What will be the ratio of flux passing through them ?
- JIPMER MBBS - 2019
- Electric Flux
View More Questions