Question:
A scanline survey between points A and B of a rock mass is shown. Consider
RQD =100×(0.12+1)×exp(−0.1λ),
where, λ is the frequency of discontinuity per m. The RQD of the rock mass is_____. (round off up to 2 decimals)
A scanline survey between points A and B of a rock mass is shown. Consider
RQD =100×(0.12+1)×exp(−0.1λ),
where, λ is the frequency of discontinuity per m. The RQD of the rock mass is_____. (round off up to 2 decimals)
RQD =100×(0.12+1)×exp(−0.1λ),
where, λ is the frequency of discontinuity per m. The RQD of the rock mass is_____. (round off up to 2 decimals)
Updated On: Jul 18, 2024
Hide Solution
Verified By Collegedunia
Correct Answer: 85
Solution and Explanation
The correct answer is: 85.00 or 87.00 (approx)
Was this answer helpful?
0
0
Top Questions on Mine Surveying
- The angle in degrees at which a ridge line intersects contours is
- TS PGECET - 2024
- Mining Engineering
- Mine Surveying
- The basic concept behind GPS is
- TS PGECET - 2024
- Mining Engineering
- Mine Surveying
- Every line has two bearings such as fore bearing and back bearing. If fore bearing is less than $180^\circ$, then what will be the back bearing?
- TS PGECET - 2024
- Mining Engineering
- Mine Surveying
- One of the tacheometric constants is additive, the other constant is
- TS PGECET - 2024
- Mining Engineering
- Mine Surveying
- The length of the tangent of a simple circular curve of radius $R$ and angle of deflection $\Delta$ is given by
- TS PGECET - 2024
- Mining Engineering
- Mine Surveying
View More Questions
Questions Asked in GATE MN exam
- In bord and pillar mining, the main load-bearing elements are:
- GATE MN - 2026
- Mine planning and its components
- The machine used for drilling blast holes in hard rock mines is:
- GATE MN - 2026
- Mine planning and its components
- Which one of the following is the most widely used method for coal extraction in surface mines?
- GATE MN - 2026
- Mine planning and its components
- Which gas is mainly responsible for explosions in coal mines?
- GATE MN - 2026
- Mine planning and its components
- The instrument commonly used for measuring horizontal and vertical angles in mines is:
- GATE MN - 2026
- Mine planning and its components
View More Questions