>
Exams
>
Mining Engineering
>
Mine Surveying
>
one of the tacheometric constants is additive the
Question:
One of the tacheometric constants is additive, the other constant is
Show Hint
Tacheometric constants include an additive and a multiplying constant.
TS PGECET - 2024
TS PGECET
Updated On:
May 28, 2025
Subtractive
Multiplying constant
Dividing constant
Indicative constant
Hide Solution
Verified By Collegedunia
The Correct Option is
B
Solution and Explanation
In tacheometry, there are two constants: the additive constant and the multiplying constant, which are used for distance calculation from staff readings.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Mine Surveying
The angle in degrees at which a ridge line intersects contours is
TS PGECET - 2024
Mining Engineering
Mine Surveying
View Solution
The basic concept behind GPS is
TS PGECET - 2024
Mining Engineering
Mine Surveying
View Solution
Every line has two bearings such as fore bearing and back bearing. If fore bearing is less than $180^\circ$, then what will be the back bearing?
TS PGECET - 2024
Mining Engineering
Mine Surveying
View Solution
The length of the tangent of a simple circular curve of radius $R$ and angle of deflection $\Delta$ is given by
TS PGECET - 2024
Mining Engineering
Mine Surveying
View Solution
In a tacheometry survey, the readings observed are given.
Instrument Station
Staff Station
Bearing of line of sight
Vertical angle
Staff readings (m)
p
A
145°
+8°
1.2, 1.7, 2.2
B
205°
+3°
0.8, 1.2, 1.6
The additive and multiplying constants of the instrument are 0 and 100, respectively. The length of the line AB in m, is____.(round off up to 2 decimals)
GATE MN - 2024
Mining Geology, Mine Development and Surveying
Mine Surveying
View Solution
View More Questions
Questions Asked in TS PGECET exam
In which year was the Earth Summit (Rio Conference) held?
TS PGECET - 2025
Environmental pollution
View Solution
A bag contains 3 red and 2 blue balls. Two balls are drawn without replacement. What is the probability that both are red?
TS PGECET - 2025
Probability
View Solution
Which of the following techniques is primarily used for the synthesis of carbon nanotubes?
TS PGECET - 2025
Strength of Materials
View Solution
The top-down approach in nanofabrication refers to:
TS PGECET - 2025
Metrology and Inspection
View Solution
The term "carrying capacity" refers to:
TS PGECET - 2025
Sustainable Development
View Solution
View More Questions