A child walks on a level surface from point P to point Q at a bearing of 30°, from point Q to point R at a bearing of 90° and then directly returns to the starting point P at a bearing of 240°. The straight-line paths PQ and QR are 4 m each. Assuming that all bearings are measured from the magnetic north in degrees, the straight-line path length RP (in meters) is ________ (rounded off to the nearest integer).
Correct Answer: 6
Solution and Explanation
Top Questions on Simple stress and strain relationships
- For a linear elastic and isotropic material, the correct relationship among Young's modulus of elasticity $(E)$, Poisson's ratio $(\nu)$, and shear modulus $(G)$ is:
- GATE CE - 2022
- Structural Engineering
- Simple stress and strain relationships
A square plate O-P-Q-R of a linear elastic material with sides 1.0 m is loaded in a state of plane stress. Under a given stress condition, the plate deforms to a new configuration O-P'-Q'-R' as shown in the figure (not to scale). Under the given deformation, the edges of the plate remain straight.
The horizontal displacement of the point (0.5 m, 0.5 m) in the plate O-P-Q-R (in mm, round off to one decimal place) is \(\underline{\hspace{1cm}}\).
- GATE CE - 2021
- Structural Engineering
- Simple stress and strain relationships
- Strain hardening of structural steel means
- GATE CE - 2021
- Structural Engineering
- Simple stress and strain relationships
Questions Asked in GATE CE exam
In levelling between two points A and B on the opposite banks of a river, the readings are taken by setting the instrument both at A and B, as shown in the table. If the RL of A is 150.000 m, the RL of B (in m) is ....... (rounded off to 3 decimal places).
- GATE CE - 2025
- Surveying and Levelling
A one-way, single lane road has traffic that consists of 30% trucks and 70% cars. The speed of trucks (in km/h) is a uniform random variable on the interval (30, 60), and the speed of cars (in km/h) is a uniform random variable on the interval (40, 80). The speed limit on the road is 50 km/h. The percentage of vehicles that exceed the speed limit is ........ (rounded off to 1 decimal place).
- GATE CE - 2025
- Traffic signs
- A symmetrical trapezoidal canal is 100 km long. The bottom width is 10 m and the side slope is 1 Horizontal : 1 Vertical. The average flow depth in the canal is 2.5 m throughout the month of April. The measurement from a Class-A evaporimeter in the vicinity of the canal indicated an average evaporation rate of 0.5 cm/day in April. The volume of water evaporated from the canal (in m³) in the month of April is close to ........ \(\times 10^3\) (rounded off to 1 decimal place).
- GATE CE - 2025
- Ground water hydrology
- During determination of the bulk specific gravity of compacted bituminous specimen, the mass in air of the specimen is 1260 g and volume is 525 cm³. The density of water is 1.0 g/cm³. The theoretical maximum specific gravity of mix is 2.510. The percentage air voids in the compacted specimen is ......... (rounded off to 2 decimal places).
- GATE CE - 2025
- Gravity Dams and Spillways
- A 5.0 m wide rectangular channel carries a discharge of 10 m³/s at a depth of 1.5 m under uniform flow. To produce critical flow conditions without affecting the upstream conditions, the channel bottom elevation should be raised (in m) by ........ (rounded off to 2 decimal places).
- GATE CE - 2025
- Microscopic and macroscopic parameters of traffic flow