List of top Textile Engineering Questions asked in OJEE

Nylon-4 is made by the polymerisation of
Dimethyl formamide (DMF) at boil is a solvent for
The no. of equations and variables in Peirce’s geometry
During drawing crystallinity of a fibre
Tenacity of polynosic in g/den
Decortication is related with
The terry towel is
The viscose solution should have a viscosity
Willowing machine is required in the processing of
Two cotton fibre varieties A and B having linear density of 3.2 and 4 (microgram/inch) respectively are tested on air flow instrument. The highest flow rate is obtained in case of
The strength utilization of yarn in a woven fabric is
Mountaineering rope should have
The correlation coefficient between packing density and porosity of a set of yarn is
The cross section of spinneret used for producing hollow fibre
If $W$ and $S$ be the wales per inch and fraction shrinkage of a knitted fabric then the machine gauge $G$ will be
Which of the following shuttleless weaving system can offer maximum fabric width?
A shuttle loom is running at 240 picks per minute. The angular velocity of bottom shaft in radian per second is $n\pi$. The value of $n$ is
A ring frame is scheduled to run with the following settings:
Linear speed of traveller = 30 m/s
Front roller delivery speed = 18 m/min
Bobbin diameter = 25 mm
Spindle rpm = 15430
What ring diameter (in mm) will be appropriate for the above settings?
Which one is correct regarding pilling resistance?
100 kg oven dry warp yarns were sized to the add-on of 8% and dried to overall moisture content of 10%. The final mass of the sized yarn will be