List of top General Science Questions asked in Bihar Industrial Training Institute Competitive Admission Test

Air used in air blast circuit breakers must:
What is the unit of heat in CGS?
On which factor does the power factor of an alternator depend?
The rotor of single-phase induction motor:
Both sides of solar cells are protected by using thin sheets in case of silicon-based PV cells. Such sheets are made up of:
The solid having twelve equal and regular pentagonal faces is known as:
The clamp meter measures:
As the speed of an alternator increases:
The form factor for the sinusoidal waveform is the ratio of:
On which of the following factors does the choice of site for hydro-electric power plant NOT depend?
A 200 V lamp takes a current of 0.5 amp and produces a total flux of 3000 lumens. Calculate the efficiency of the lamp.
Which material is used to manufacture yoke of DC machines?
Which of the following is NOT a type of wiring?
In a 4-band carbon composition resistor, the fourth band indicates:
The regulator of an electrical fan is wound with:
A soldering material is made up of copper and tin. If the material consists of 72% copper, then what will be the ratio of copper and tin in the material?
Which of the following is pertaining to KVL?
If the length of a conductor is doubled and the cross-section area is halved, the resistance will be:
Which electrical machine has the highest efficiency?
The tendency of alternating current to concentrate near the surface of the overhead conductor is called:
The power supplied to a balanced star connected load is:
When two SCRs are connected in anti-parallel combination, it is called:
The phase difference of voltages and currents in three-phase systems is:
A Zener diode has:
The equation of an alternating current is \(14\sin(1256t)\), determine the frequency.