List of top Mechanical Engineering Questions asked in Andhra Pradesh Post Graduate Engineering Common Entrance Test

Which of the machining processes uses the principle of Faraday’s law for material removal?
The instantaneous centre of rotation of a rigid thin disc rolling on a plane rigid surface is located at:
The gears employed for connecting two non-intersecting and non-parallel, i.e., non-coplanar shafts are:
A master gauge is an:
For the two shafts connected in parallel, find which statement is true?
Gating system in casting controls:
Heat transfer takes place according to:
Forecasting in PPC helps in:
The locus of elevations that water will rise in a series of pitot tubes is called:
Amount of external energy required to deform an elastic body is called:
Which material is commonly used for pattern making?
Balancing of a rigid rotor can be achieved by appropriately balancing masses in:
The primary mechanism of material removal in electrochemical machining (ECM) is:
As the distance from the leading edge increases, the thermal boundary layer thickness:
The value of Poisson's ratio for any material cannot exceed:
Strength of a material is its ability to resist:
In the S-N curve, "N" represents :
Provision of fins on a given heat transfer surface will be more, if there are:
In wire drawing operation, the maximum reduction per pass for perfectly plastic material in ideal condition is:
Quick return mechanism is an inversion of:
Least count of a micrometer screw gauge is usually:
In an open system, both ............. and ............. can cross the boundary?
Reheating in Brayton cycle:
In metal cutting operations, discontinuous chips are produced while machining:
In a planar truss, the number of members (m), joints (j), and reactions (r) are related by: