List of top Questions asked in Andhra Pradesh Post Graduate Engineering Common Entrance Test

The gears employed for connecting two non-intersecting and non-parallel, i.e., non-coplanar shafts are:
Which of the machining processes uses the principle of Faraday’s law for material removal?
A master gauge is an:
Gating system in casting controls:
For the two shafts connected in parallel, find which statement is true?
Amount of external energy required to deform an elastic body is called:
Balancing of a rigid rotor can be achieved by appropriately balancing masses in:
Forecasting in PPC helps in:
Heat transfer takes place according to:
The locus of elevations that water will rise in a series of pitot tubes is called:
Which material is commonly used for pattern making?
Strength of a material is its ability to resist:
As the distance from the leading edge increases, the thermal boundary layer thickness:
Provision of fins on a given heat transfer surface will be more, if there are:
The primary mechanism of material removal in electrochemical machining (ECM) is:
In the S-N curve, "N" represents :
The value of Poisson's ratio for any material cannot exceed:
Quick return mechanism is an inversion of:
In wire drawing operation, the maximum reduction per pass for perfectly plastic material in ideal condition is:
In metal cutting operations, discontinuous chips are produced while machining:
Least count of a micrometer screw gauge is usually:
In an open system, both ............. and ............. can cross the boundary?
Reheating in Brayton cycle:
Seam welding used for metal sheets having thickness in the range:
Which of the following is a Taylor’s tool life equation, where V-cutting speed (m/min), T-tool life (min), n-exponent and C-constant?