Question:
What will be the relative density?
M = 0.5 percentage of air voids
γmin = 1.3 gm/cc
γmax = 1.8 gm/cc
What will be the relative density?
M = 0.5 percentage of air voids
γmin = 1.3 gm/cc
γmax = 1.8 gm/cc
M = 0.5 percentage of air voids
γmin = 1.3 gm/cc
γmax = 1.8 gm/cc
Updated On: Jul 1, 2024
Hide Solution
Verified By Collegedunia
Correct Answer: 0.133
Solution and Explanation
The correct answer is 0.133 (assuming porosity = 0.5)
Was this answer helpful?
0
0
Questions Asked in GATE CE exam
- An electricity utility company charges ₹7 per kWh. If a 40-watt desk light is left on for 10 hours each night for 180 days, what would be the cost of energy consumption? If the desk light is on for 2 more hours each night for the 180 days, what would be the percentage-increase in the cost of energy consumption?
- GATE CE - 2025
- Logical and Analytical Reasoning Skills
- During determination of the bulk specific gravity of compacted bituminous specimen, the mass in air of the specimen is 1260 g and volume is 525 cm³. The density of water is 1.0 g/cm³. The theoretical maximum specific gravity of mix is 2.510. The percentage air voids in the compacted specimen is ......... (rounded off to 2 decimal places).
- GATE CE - 2025
- Gravity Dams and Spillways
In levelling between two points A and B on the opposite banks of a river, the readings are taken by setting the instrument both at A and B, as shown in the table. If the RL of A is 150.000 m, the RL of B (in m) is ....... (rounded off to 3 decimal places).
- GATE CE - 2025
- Surveying and Levelling
A one-way, single lane road has traffic that consists of 30% trucks and 70% cars. The speed of trucks (in km/h) is a uniform random variable on the interval (30, 60), and the speed of cars (in km/h) is a uniform random variable on the interval (40, 80). The speed limit on the road is 50 km/h. The percentage of vehicles that exceed the speed limit is ........ (rounded off to 1 decimal place).
- GATE CE - 2025
- Traffic signs
- A 5.0 m wide rectangular channel carries a discharge of 10 m³/s at a depth of 1.5 m under uniform flow. To produce critical flow conditions without affecting the upstream conditions, the channel bottom elevation should be raised (in m) by ........ (rounded off to 2 decimal places).
- GATE CE - 2025
- Microscopic and macroscopic parameters of traffic flow
View More Questions