Question:
To have large selectivity in a series LCR circuit
To have large selectivity in a series LCR circuit
Updated On: Jan 16, 2024
- L should be large, R should be small
- Both L and R should be large
- L should be small, R should be large
- Both L and R must be small
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
Quality factor of $LCR$ circuit is
$Q = \frac{\omega_o L}{R}$
If $Q$ is large for $LCR$ circuit i.e. $R$ is low and $L $ is large then the circuit is more selective.
Was this answer helpful?
1
0
Top Questions on LCR Circuit
- The amplitude of the charge oscillating in a circuit decreases exponentially as $Q = Q_0 e^{-Rt/2L}$, where $Q_0$ is the charge at $t=0s$. The time at which charge amplitude decreases to 0.50 $Q_0$ is nearly:
[Given that $R = 15 \Omega$, $L = 12 mH$, $ln(2) = 0.693$]- NEET (UG) - 2024
- Physics
- LCR Circuit
- A logic circuit provides the output y as per the following truth table:
A B Y 0 0 1 0 1 0 1 0 1 1 1 0
The expression for the output Y is:- NEET (UG) - 2024
- Physics
- LCR Circuit
- Given below are two statements:
Statement I: In an LCR series circuit, current is maximum at resonance.
Statement II: Current in a purely resistive circuit can never be less than that in a series LCR circuit when connected to the same voltage source.
In the light of the above statements, choose the correct from the options given below.- JEE Main - 2024
- Physics
- LCR Circuit
- For a given series LCR circuit, it is found that maximum current is drawn when value of variable capacitance is $2.5 \, \text{nF}$. If resistance of $2000 \, \Omega$ and $100 \, \text{mH}$ inductor is being used in the given circuit. The frequency of AC source is ____ $\times \, 10^3 \, \text{Hz}$. (Given $\pi^2 = 10$)
- JEE Main - 2024
- Physics
- LCR Circuit
- A series LCR circuit is subjected to an AC signal of 200 V, 50 Hz. If the voltage across the inductor (L = 10 mH) is 31.4 V, then the current in this circuit is ________ :
- JEE Main - 2024
- Physics
- LCR Circuit
View More Questions
Questions Asked in COMEDK exam
- The standard electrode potential for Daniell cell is $1.1\, volt$. What is the standard Gibbs energy for the reaction?
- COMEDK - 2015
- Gibbs Free Energy
- The girth or diameter of the stem increases due to the activity of the following
- COMEDK - 2015
- The Stem
- More number of oxidation state are exhibited by the actinoids than by lanthanoids. The main reason for this is :
- COMEDK - 2015
- The Actinoids
- Two amplifiers are connected one after the other in series (cascaded). The first amplifier has a voltage gain of $10$ and the second has a voltage gain of $20$. If the input signal is $0.01\, volt$, what is the output $ac$ signal ?
- COMEDK - 2014
- Transistors
- Three charges $-q, +Q$ and $-q$ are placed at equal distances along a straight line. If the total $P.E.$ of the system is zero, the ratio $ \frac{Q}{q} $ becomes
- COMEDK - 2014
- Electrostatic potential
View More Questions
Concepts Used:
LCR Circuit
An LCR circuit, also known as a resonant circuit, or an RLC circuit, is an electrical circuit consist of an inductor (L), capacitor (C) and resistor (R) connected in series or parallel.
Series LCR circuit
When a constant voltage source is connected across a resistor a current is induced in it. This current has a unique direction and flows from the negative to positive terminal. Magnitude of current remains constant.
Alternating current is the current if the direction of current through this resistor changes periodically. An AC generator or AC dynamo can be used as AC voltage source.
