Three resistors $1\,\Omega , 2\,\Omega$ and $3\,\Omega $ are connected to form a triangle. Across $3\,\Omega$ resistor a $3\,V$ battery is connected. The current through $3\,\Omega$ resistor is
- 0.75A
- 1A
- 2A
- 1.5A
The Correct Option is B
Solution and Explanation
The equivalent circuit will look like (since the two resistances of $1 \,\Omega$ and $2 \,\Omega$ are in series, which form $3 \,\Omega$ which is in parallel with $3 \,\Omega$ resistance).
Therefore, the effective resistance is
$\frac{(1+2) \times 3}{(1+2)+3}=\frac{3}{2} \Omega$
$\therefore$ Current in the circuit,
$I=\frac{3}{(3 / 2)}=2\, A$
$\therefore$ Current in $3 \,\Omega$ resistor $=\frac{I}{2}$
$=1 \,A$
Top Questions on Resistance
- Two wires A and B are made up of the same material and have the same mass. Wire A has radius \(2.0 \, \text{mm}\) and wire B has radius \(4.0 \, \text{mm}\). The resistance of wire B is \(2 \, \Omega\). The resistance of wire A is _____ \( \Omega \).
- JEE Main - 2024
- Physics
- Resistance
- To determine the resistance \( R \) of a wire, a circuit is designed below. The V-I characteristic curve for this circuit is plotted for the voltmeter and the ammeter readings as shown in the figure. The value of \( R \) is \( \dots \dots \dots \Omega \).
- JEE Main - 2024
- Physics
- Resistance
A 16Ω wire is bent to form a square loop. A 9 V battery with internal resistance 1Ω is connected across one of its sides. If a 4μF capacitor is connected across one of its diagonals, the energy stored by the capacitor will be \(\frac{x}{2}\) μJ, where \(x =\) _____.
- JEE Main - 2024
- Physics
- Resistance
- A wire of resistance \( R \) and length \( L \) is cut into 5 equal parts. If these parts are joined in parallel, then the resultant resistance will be:
- JEE Main - 2024
- Physics
- Resistance
A galvanometer having coil resistance 10 Ω shows a full scale deflection for a current of 3 mA. For it to measure a current of 8 A, the value of the shunt should be:
- JEE Main - 2024
- Physics
- Resistance
Questions Asked in VITEEE exam
- Two identical blocks A and B, each of mass 'm' resting on a smooth floor are connected by a light spring of natural length L and spring constant K, with the spring at its natural length. A third identical block 'C' (mass m) moving with a speed v along the line joining A and B collides with A. the maximum compression in the spring is
- VITEEE - 2023
- work, energy and power
- Assertion :
The binding energy of the nucleus increases with the increase in atomic number.
Reason :
Heavier elements have a greater number of non-radioactive isotopes than radioactive isotopes. - The half-life of radioactive radon is 3.8 days. The time at the end of which \(\frac{1}{20}th\) of the Radon sample will remain undecayed is (given log10e=0.4343)
- Which element has more electron gain enthalpy among chalcogen group?
- VITEEE - 2022
- sulphur
- Coin is tossed till heads is obtained what is expectation of no. of coin tosses
- VITEEE - 2022
- Random Variables
Concepts Used:
Resistance
Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.
R=V/I
In this case,
v = Voltage across its ends
I = Current flowing through it
All materials resist current flow to some degree. They fall into one of two broad categories:
- Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
- Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.
Resistance measurements are normally taken to indicate the condition of a component or a circuit.
- The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
- The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.