Question:
The sequence of devices in the order of decreasing frequency of operation are
The sequence of devices in the order of decreasing frequency of operation are
Show Hint
Frequency handling: MOSFET>IGBT>GTO
Updated On: May 23, 2025
- GTO, MOSFET, IGBT
- MOSFET, IGBT, GTO
- GTO, IGBT, MOSFET
- MOSFET, GTO, IGBT
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
- MOSFETs operate at highest frequencies.
- IGBTs have medium switching speeds.
- GTOs (Gate Turn-Off Thyristors) are slowest.
Hence, frequency order: MOSFET>IGBT>GTO
- IGBTs have medium switching speeds.
- GTOs (Gate Turn-Off Thyristors) are slowest.
Hence, frequency order: MOSFET>IGBT>GTO
Was this answer helpful?
0
0
Top Questions on Power Electronics
- The frequency modulation of a 3-\(\phi\) sinusoidal pulse width modulation is an odd multiple of 3. Then the output line voltage contains
- TS PGECET - 2024
- Electrical Engineering
- Power Electronics
- Which of the following triggering circuits can be used in feed-back control systems?
- TS PGECET - 2024
- Electrical Engineering
- Power Electronics
- A 1-\(\phi\) inverter is fed with an RLC series load of \( R = 1\,\Omega, X_L = 6\,\Omega \) and \( X_C = 7\,\Omega \). Then the phase angle between fundamental current and third harmonic voltage is
- TS PGECET - 2024
- Electrical Engineering
- Power Electronics
- A 1-\(\phi\) AC voltage controller feeds a load resistance of \( R \). If firing angles of two switches are off set at \( 180^\circ \), then rms value of input current is
- TS PGECET - 2024
- Electrical Engineering
- Power Electronics
- The ratio of latching current to holding current of SCR
- TS PGECET - 2024
- Electrical Engineering
- Power Electronics
View More Questions
Questions Asked in TS PGECET exam
When the enable data input \( D = 1 \), select inputs \( S_1 = S_0 = 0 \) in the 1×4 Demultiplexer, then the outputs \( Y_0, Y_1, Y_2, Y_3 \) are
- TS PGECET - 2024
- Analog and Digital Electronics
The \( Z \) parameter \( Z_{21} \) of the following circuit is
- TS PGECET - 2024
- Electric circuits and fields
The \( h \) parameters of the following circuit is
- TS PGECET - 2024
- Electric circuits and fields
For an input voltage \( v = 10 \sin 1000t \), the Thevenin's impedance at the terminals X and Y for the following circuit is
- TS PGECET - 2024
- Electric circuits and fields
- Newton-Raphson iterative formula for finding \[ \frac{1}{\sqrt{N}}, (N>0) \] is
- TS PGECET - 2024
- Newton Raphson Method
View More Questions