The output voltage of a transistor amplifier is 12 V when the input is 2 V. What is the voltage gain of the amplifier?
Show Hint
- 6
- 5
- 4
- 3
The Correct Option is A
Solution and Explanation
Top Questions on Analog Electronics
A 3-bit DAC is implemented using ideal opamp and switches as shown in the figure. Each of the switches gets closed when its corresponding digital input is at logic 1. For a digital input of 110, the resistance \( R_{in} \) seen from the reference source and the current \( I \), are
- GATE IN - 2025
- Signals and Systems
- Analog Electronics
A chopper amplifier shown in the figure is designed to process a biomedical signal \( v_{in}(t) \) to generate conditioned output \( v_{out}(t) \). The signals \( v_{in}(t) \) and \( v_{os}(t) \) are band limited to 50 Hz and 10 Hz, respectively. For the system to operate as a linear amplifier, choose the correct statement from the following options.
- GATE IN - 2025
- Signals and Systems
- Analog Electronics
In the circuit shown, assume that the BJT in the circuit has very high \( \beta \) and \( V_{BE} = 0.7 \) V, and the Zener diode has \( V_Z = 4.7 \) V. The current \( I \) through the LED is ________ mA (rounded off to two decimal places).
- GATE IN - 2025
- Signals and Systems
- Analog Electronics
For the ideal opamp based circuit shown in the figure, the ratio \( \frac{V}{I} \) is
- GATE IN - 2025
- Signals and Systems
- Analog Electronics
- For the RC circuit shown, the condition for obtaining \( \left|\frac{V_0}{V_{\text{in}}}\right| = \frac{1}{3} \) at frequency \( \omega \) rad/sec is:
- TS PGECET - 2024
- Instrumentation Engineering
- Analog Electronics
Questions Asked in TS PGECET exam
- The transfer function of a system is given by: \[ \frac{Y(s)}{X(s)} = \frac{10}{s^2 + 3s + 10} \] What is the damping ratio of the system?
- TS PGECET - 2025
- Control Systems
- Which of the following is not a type of process scheduling in operating systems?
- TS PGECET - 2025
- Operating Systems
- What is the size of the address bus in a 16-bit microprocessor?
- TS PGECET - 2025
- Microprocessors
- What is the bandwidth of a signal if the highest frequency is 5 kHz and the lowest frequency is 2 kHz?
- TS PGECET - 2025
- Signals and Systems
- Which of the following is a device used to connect multiple networks and operate at the network layer of the OSI model?
- TS PGECET - 2025
- Computer Networks