Question:

The equivalent resistance between the points P and Q in the network shown in the figure is given by:

Updated On: May 19, 2022
  • $2.5 \, \Omega $
  • $7.5 \, \Omega $
  • $10 \, \Omega $
  • $12.5 \, \Omega $
Hide Solution
collegedunia
Verified By Collegedunia

The Correct Option is B

Solution and Explanation

Key Idea: The given circuit is a balanced Wheatstone bridge.
The equivalent circuit is shown below:

In the given circuit, the ratio of resistances in the opposite arms is same
$ \frac{P}{Q}=\frac{10}{10}=\frac{1}{1} $
$ \frac{R}{S}=\frac{5}{5}=\frac{1}{1} $
Hence, bridge is balanced.
The given circuit now reduces to

Here, $ 10\,\Omega $ and $ 5\,\Omega $ resistors are in series, therefore

Now, the two $ 15\,\Omega $ resistors are connected in parallel, hence equivalent resistance is
$ R=\frac{15\times 15}{15+15}$
$=\frac{225}{30}=7.5\,\Omega $
Was this answer helpful?
0
0

Concepts Used:

Resistance

Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.

R=V/I

In this case,

v = Voltage across its ends

I = Current flowing through it

All materials resist current flow to some degree. They fall into one of two broad categories:

  • Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
  • Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.

Resistance measurements are normally taken to indicate the condition of a component or a circuit.

  • The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
  • The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.