Question:
Sensor used to measure the speed of rotating shaft is called:
Sensor used to measure the speed of rotating shaft is called:
Updated On: Mar 21, 2024
- Tactile sensor
- Tachogenerator
- Rotameter
- Photodiodes
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
The correct option is (B): Tachogenerator
Was this answer helpful?
0
0
Top Questions on Shafts
- Open bearing is useful for shafts rotating at
- If a circular shaft is subjected to a torque T and a bending moment M, the ratio of maximum shear stress to maximum bending stress given by:
- Given below are two statements: One is labelled as Assertion (A) and the other is labelled as Reason (R).
Assertion (A): The cross-sections of the shaft which are plane before twist, remain plane during and after twist.
Reasons (R): The twisting moment does not vary with the radius of the shaft.
In the light of the above statements, choose the most appropriate answer from the options given below: - A solid circular shaft of diameter 'd' is subjected to a combined bending moment 'M' and torque "T. The material property to be used for designing the shaft using the relation \(\frac{16}{\pi d^3} \times \sqrt{M^2+T^2}\) is:
- A solid circular shaft is required to transmit a torque of 100 Nm. If the permissible shear stress for the material is 180 MPa, the diameter of a shaft in mm is:
(Assume FOS as 2)
Questions Asked in CUET PG exam
- Find out the degree of the differential equation \(\frac {d^2t}{ds^2}+(\frac {dt}{ds})^2+2t=0\)
- CUET (PG) - 2023
- Differential Equations
- The surface area of the sphere x2 + y2 + z2 = 9 lying inside the cylinder x2 + y2 = 3y is
- CUET (PG) - 2023
- Surface Area of Cube, Cuboid and Cylinder
- The Ombudsman in a newspaper organisation represents the point of view of the ___.
- CUET (PG) - 2023
- Journalism
- The orthogonal trajectories of the family of curves y = \(ax^3\) is
- The minimum distance of the point (3, 4, 12) from the sphere x2 + y2 + z2 = 1 is
- CUET (PG) - 2023
- Coordinate Geometry
View More Questions